Search results

Ona BX tractor, the left side of the engine is on the right side of the tractor as the engine is mounted backward. The threaded hole for the block heater is on the righthand side of the tractor.:D

Take hold of the cable at the injection pump and pull on it. I would bet you can pull out a section of it from the sheath.

You will find there is also a radiator next to the battery. Your RTV has two radiators.

K5955-34360

Re: Rtv-900x Do you have an RTV 900X or an RTV X900? Depending on where the "X" is makes them two completely different critters. Park brake to the left of the seat is 900X. Park brake on the dash to the left of your steering wheel is X900. A 900X has Low, Med and Hi gear ranges, X900 has...

There are two filters, a Hydraulic suction filter on the Right side of your tractor and an HST filter on the Left side of the tractor. Your new HST filter will be painted yellow.

You will never get the wire ring out without tapping down the inner housing that your wiper seal is in. Until it is moved down about an 1/8", there is not enough room for it to come out. Also, if you drill a small hole thru the barrel in line with the wire groove, you can use a pick to unseat...

Error code 9302 is almost always a restricted sedimenter inlet or plugged fuel filter. The restriction creates too low of fuel pressure in the high-pressure fuel rail.

Yes, it is supposed to rotate and yes, it needs to be lubed regularly.

This model does not have a high engine temperature shut down.

If the seal ring in the radiator is eroded, it will not hold pressure and your coolant will be lost through the surge bottle vent. You will need to replace the radiator. It's a very common result of the unit being overheated. The plastic tank radiators work very well as long as they are kept...

It is normal for the loader to settle over time as the spools in the valve are not a positive seal, they are metal to metal. It is impossible for the loader to stay up overnight.

There are wire snap ring on each end inside of the barrel. Take a piece of pipe and drive end glands into the barrel, remove wire rings and drive glands out using a punch inside of the threaded hole in the shaft.

Yes, they do.

Pry the seal from axle housing, remove the snap ring, the axle will now pull out of the housing. Remove another snap ring and tap bearing off of the axle shaft. Replace seal and reverse procedure.

Looks like the parking brake or PTO switches for an L series. Parking brake switch would be above the pedals, under the dash cover. PTO would be below the control lever.

You can still get a gear drive tractor of almost any size from Kubota, just not the BX series. There has never been a BX other than a hydrostatic transmission model.

We are both very well aware that it probably is not the original engine. PS : Kubota never built a V2203 motor, only V2203 engine.

The BX 80's operators manual only lists changing only the hydro filter at the first 50 hours but the Service manual shows changing the oil, filter and cleaning the screen at the first 50-hour service. The BX1880, BX2380 and BX2680 are the same manuals.

Compare the new belt to your old belt. If the new one is a hair shorter than your old one, it is probably correct. Installing a new Kubota fan belt is like trying to stretch a gnat's ass over a rain barrel.