Latest activity
-
Bbsamot69 replied to the thread L4400 fel not working.Yes, that is what I did on each cylinder and air came out opposite fitting
-
PPoTreeBoy replied to the thread Kubota 7030.I'm not in the market, but a picture on here might pique some interest. There's some of us tractor voyeurs on here, too.
-
GGrampus replied to the thread BX23s throttle snapped... might have an improvement idea.Well, when it's cold outside .......;)
-
PI was laying across the back window and launching into the back of the front seat when the driver slammed on the brakes 😎😎😎😎😎😎
-
PAnd all along I thought it was the woman’s right arm that was attracting attention…😂
-
IInTheWoods replied to the thread PTO drive for a Miller Bobcat welder?.^right. And HP remains constant (exclusive of frictional loss).
-
Kkalapacs replied to the thread Kubota b6000.If I remove the dosing pump and put it back in, do I need to mark the flywheel?
-
IHP = speed x torque. You can't change one without affecting at least one other. Six times more speed means six times less torque.
-
PPoTreeBoy replied to the thread L4400 fel not working.That would be very unusual. Confirm, in the picture below, you removed both hoses circled in green? Then forced air in one and air...
-
-
GGreensvilleJay replied to the thread Crank handle grip replacement.you can buy plastic handles ( maybe McMCarr in USA ? ) .I have a bucket full of handles and knobs that 'magically' appeared here one...
-
EEngineer42 replied to the thread Good Morning.That's one of the reasons we only use the dead bolt lock on our latch, and not locking the handle. Second reason is the ears on the...
-
WWorkerbee replied to the thread Crank handle grip replacement.If you take that cover off the top of the jack you will see that you can remove the handle by driving out a roll pin. You can buy...
-
Daren Todd replied to the thread Daily Chuckle.I was laying across the back window and launching into the back of the front seat when the driver slammed on the brakes 😎😎😎😎😎😎 -
Daren Todd replied to the thread Daily Chuckle.As your looking at the photo 🤪🤪🤪
-
Never been in one. My wife goes to Costo once a month, never been in that either. Closest I get to any of that is Harbor Freight.
