Search results

Well it took my local dealer what seemed like a year and a day but they finally came through and my ROPS have arrived. Ordered through the Kubota Safety Program, they only ran me about $300. Only one bolt wouldn't cooperate but I coerced it into place.

So after my last post about heating my B7200 in which an inline coolant heater was suggested, I've come to the conclusion that my lower radiator hose is no where long enough to install one. So on to the next option. How many people have used the thermalsyphon heaters and with how much success?

I've read that on these forums that the best solution to early kubota cold weather issues is the magnetic oil pan heater however after searching on Amazon for a solution an item came up, a water jacket heater, that claims to fir the D950 engine. Had anyone bought one? Knows if it fits or not...

This is how my day went. So while working on my front wheel bearings I took a small shortcut. Rather than dragging the floor jack over I used the FEL to lift the front end off the ground, through the jack stands under the uprights, and lowered the tractor onto them. This resulted in the...

Had bad wheel bearings on my front left wheel so I pulled them out and replaced them today. While the front end was off the ground I noticed a lot of vertical play where the knuckle meets the main axle case. I've looked through the parts catalogs and my question before I dive into is, Is there...

She's been used, abused, and put away wet. Lay down your favorite degreaser so I can tell what I'm looking at on my dirty girl.

The 3 point on my B7200D (with FEL) is acting erratically and I believe the control lever my be to blame. It dips then raises without a real discernable pattern. The lever has no tension to it at all and flops around (currently helps in place by some bailing twine). With the tractor off, I...

Found water in my trans/hydraulic oil and planned on changing it a few times. After the first change I have no hydraulics. Yes there is enough fluid in there. No noises (at least none I can hear over the D950). Does it need to be primed?

I'm the new owner of a B7200. I think I've got a bad generator. As I test it, if it needs replacement, is it a good idea to just upgrade to the Tisco alternator? Especially if I plan on adding lights etc. I know it was an option, so does it bolt right in place of the generator or does it...

I just purchased a B7200D. Everything seems to work (other than the water in the trans) but it is missing it's ROPS. Has anyone had luck finding them or adapting a set to a B series or even making their own? Is it best to just look for someone with a parts tractor and hope to get lucky? Any...