Search results

Do you have any freeplay in the clutch pedal? Meaning, when the clutch is not pressed, is there a bit of play before the clutch pedal hits a hard spot? If someone is riding the clutch and it is out of freeplay, it will cause it to slip. There's a rod and clevis under the hood that goes to the...

It's cast together, you will have to remove the transmission as a whole, remove the HST unit, and then remove that front cover and replace. There's a few o rings, but most of it is sealed with Ultra Grey silicone. For a guy that's never done it before, about a 20 hr job.

Without seeing it, I would almost think a bad seal on the steering cylinder piston.

You really should have done pressure and flow tests on the system before you tore it apart, now you're relying on just your eyesight to show you what's wrong. Obviously, there's nothing wrong with the gears, if there were, you wouldn't have any movement of the shaft, or it would make a...

Do you have any auto guidance systems mounted on the tractor?

Atleast need a model

From the looks of the panel, it was pretty brittle to begin with.

Shouldn't have to pull the ROPS, but the fenders and platform pieces will need to be pulled. Take alot of pictures of the right side platform, where all the cruise control and brake pedal linkages hook up, you'll thank yourself later

You do NOT want to put any other size of tire that what is on it already, as your front ring and pinion are matched to turn the same speed as your rear ring and pinion if you're in 4wd. Putting a wrong size tire on front or rear can cause catastrophic damage in the front axle and/or rear end

The seat base is plastic, all you gotta do is lean just right, or wrong, and it will make that switch sense that you're out of the seat and shut down

You dont have to remove the seat knob, just the 3pt lower rate knob. I take a long prybar and hit it with a hammer on the backside of the knob, should pop off.

It will, but I wouldn't use it if you can avoid it. It's thinner, so it's easier to leak out of the output shaft seal

There's no way to test the sensor, it's a hall effect sensor, you can only test the harness going to it. If that checks out, assume the sensor bad. The sensor is behind the loader frame on the right hand side, at the bellhousing. You can use a long extension and socket to remove the cover and...

Crankshaft position sensor abnormality. The error is past after the key is switched off, however the ECU is storing the code. There's a way to clear the code, but your dealer knows how

As a generic Pxxxx code, it's showing an issue with the fuel pressure regulator, the first 2 are showing the abnormalities, 2nd set of codes is showing an open circuit in pressure regulator. Nothing that you'll be able to fix yourself, for sure.

The plug on the side is the fill and the check plug. There should be a drain, but if not pull the top cover off and suck it out with a suction gun and replace. They originally came with UDT, then most of them were switched over to gear lube, however, I have best luck using "00" grease. It's...

K3111-98600 is the kit number

Those DTC's that you're referring to only being available thru the dealer is because they are only useful to the dealer. You have to have a laptop with the Kubota diagnostic software to read the DTC, and then monitor the tractor to watch what caused the DTC to set. As far as every tractor...

Still betting it's the seal, seen it enough times

If it tries to shut the motor off when you press the HST pedal, the seat switch is sensing that you're out of the seat. Check the seat switch