Search results

What about some more pics, from the little bit one can see, it does look mint!

http://gcironparts.com/Kubota%20EngineIMAGES/2910D722B146_1.JPG http://gcironparts.com/Kubota%20EngineIMAGES/2910D722B146_2.JPG

If it's white smoke coming from your breather, it "could be" white water vapour, indicating a blown head gasket or similar.

Did this slow down just happen, or always been there? Would shortening the linkage adjuster give you more forwards actuation and slightly less reverse travel?

Ebay? No idea but at $12 worth a shot, plenty others http://www.ebay.com/itm/231481943234

Thank for the info NIW Yes the smaller Kubota "J series" and "GL series" gensets (up to ~20kW) run 2 pole gensets at 3600 @ 60Hz or 3000 @ 50Hz, engines are Z482, D722, D1005 & V1305. The 4 pole heavier duty ones run at 1800/1500 from ~14 kW and up. The engines are also bolted up to other...

Hi NIW, Got another one for you, generally speaking, do you see/or have you noted any differences in valve settings on kubota engines that run full time/full load constant 3600 rpm as genset prime movers, compared to the same engine in tractors? (or do you personally set them differently) I'm...

HI NIW, There's only a cats whisker in it but is that measure an update on the info in the workshop manuals at .15-19mm and .145-.185mm for the 750A and 750B? I understand over time they probably work out what works best, but seeing they closed the setting slightly with the B, it's interesting...

Not sure what you are asking, the specs listed at the start are close enough to the 750B manual I have at .145 .185 ? Remember this is a tolerance/range. .145 = 5.7 thou .15 = 5.9 thou .185 = 7.3 thou .19 = 7.5 thou .2 = 7.9 thou So set them between 6 and 7.5~8 thou from the above

Don't know the engine any chance the oil pressure sender snapped off or fell out?

No idea on quality, 17 gpm pto, plenty other to choose from http://www.surpluscenter.com/Hydraulics/Hydraulic-Pumps/PTO-Pumps/7-8-CU-IN-PRINCE-HC-PTO-9A-PTO-PUMP-540-RPM-9-1047-9.axd

Neutral start switch?

Is the shaft center drilled, or can you drill it further and then drill another greasing port into the shaft?

NIW, I was going to ask if you have any long term feedback on these Aftermarket Kubota Cylinder Heads? This is a Bare Head Which Comes With All Valve Train Parts. Unassembled as Supplied by Aftermarket Kubota Standards. Then I read on and funny thing it then says they are "Manufactured by...

Clean it up with some degreaser, throw some talc or flour on it and look/find where the leaks are originating from. Take some pics and someone here will help you through the process of fixing the leak with orings or thread sealant or tape. Someone else may also be interested in buying the valve...

2 different spools, one will have float, maybe regen on the other so different detents I expect?

Far out, one of those eh!

How close is a MX5000, there's one on the net if you do a search, not sure if it's HST

Should have mentioned, only if the spools are "wholly" round without flat detent positions or locating bosses etc., which they probably are but be sure to check. If your valve is sloppy/not sitting in the detent position, or grabbing when trying to move from the detent position they may be...

On machines with a centre pivot. Maybe you missed a bit here eh!