Search results

Have your dealer pull up PSB-2021-007-E-R1 M-Series; Countermeasure for Defective Fuel Injector on M6060, M7060, and M4

The DPF can not be cleaned by "WASHING" it. It must be disassembled and professionally baked in a very high-temperature oven/kiln.

Could you provide a detailed step-by-step procedure for vacuum testing a Diesel engine????

Perhaps since there are multiple part numbers for the Belville washers depending on the deck, we should find out what model number the deck is before we guess which washers it takes.

Almost every unit Kabota builds has a fuel lift pump no matter where the fuel tank is located.

Also, plugging into a faulty switch will not affect whether it will run. There is no connection between the oil pressure and the fuel-shut-off solenoid.

The B2650 tractor will start and run just fine with the engine oil pressure switch unplugged. Its only function is to turn on or off the oil pressure light.

That question is tricky to answer until we first know what model your RTV is, there are vast differences between the different models. Is this unit a model RTV1140CPX or is it an RTV-X1140??? The RTV1140 has the cylinder mounted in a removable mount on each end. You can remove the 4 bolts from...

Remove the hoses from the steering cylinder and put a steel JIC plug at each hose's end. Start the engine and try to turn the steering wheel. It should feel like it did when fully turned to the steering stops. That will confirm which has failed, the cylinder or the steering valve. It is the...

Drain the oil down to the Full mark on your dipstick, then run to to see what happens.

You can get a cheap injector or you can get a good injector, you can't get a good cheap injector. Buy one from either a Kubota dealer or Oregon Fuel Injection.

Here are the schematics for your Z725. The Brake and set switches have 4 terminals because they are two switches in one. One circuit in the switch can be Normaly Open and the other circuit Normaly Closed within the same switch. I seldom work on them so I have to look it up each time I mess with...

All your dealer has to do is log into their Kubotalink and put PSB-2020-034 in the search line. It will bring up the PSB in its entirety. Check your private messages for more info.

You can check the filters but they are unrelated to the compressor.

Yes, the system pressure is near 0 PSI with all spools in neutral.

What is the voltage at the shut-off solenoid wire when the unit does not shut off?

The connector is located on the lower left side of the transaxle, in front of the Range shifter.

Just a thought, watch your inner and outer tie rod ends while you are rocking the wheel in and out by hand.

Error 20 is for both Hydrostat and GST tractors.

You are correct, I forgot to add the plugged port.