Search results

  1. eserv

    3830 GST PTO Problem

    You'll need to do a pressure test to find if it's a pressure problem or a failed clutch pack. Likely a clutch pack as Kubotatech wrote if everything else is ok. The intellapanel doesn't "know" if the pto is actually working. it just knows you've engaged the lever and the engine is running. Ed
  2. eserv

    If you own a gun!

    Nice picture! :D
  3. eserv

    Hi Vic This hose failure is quite common. It could cause hyd. pump cavitation and ultimate...

    Hi Vic This hose failure is quite common. It could cause hyd. pump cavitation and ultimate failure but so far I've only seen jerky hydraulics and steering. Ed
  4. eserv

    brand new B2920 won't crank??

    The new M---X tractors DO have a diagnostic port that we can connect a laptop to. It gives us a LOT of information that the owner might not want divulged as well! Ed
  5. eserv

    L2900 Hydraulic leak - Help!

    Here is a diagram of the parts, Sleeve (d) has moved forward out of seals (f) The spacer sleeve (1) provided in the kit along with the orings (2) will hold the sleeve in place. you could get the spacer sleeve and orings and install them pushing the sleeve back into place and it should repair it...
  6. eserv

    L2900 Hydraulic leak - Help!

    If your L2900 is older than 61866 then it is likely that the sleeve inside the seal on the front axle propeller shaft has moved forward out of the seal. there is a service bulletin (ag001-98) about this. The kit to repair it is part number TA040-98000 Kubota paid 5 hr's to perform the repair...
  7. eserv

    How long should it take?

    How many hours did they charge you for? And were there any complications in the job? Sometimes a couple of rusted or broken bolts can eat up a lot of time. Ed
  8. eserv

    L175 Valve adjustment

    Yes, I mean one complete turn of the flywheel. When the valves are "rocking" ( one just closing and the other just starting to open) the piston is at Top Dead Center (TDC) Turn it one complete turn and it is again at top dead center but this time at the firing position, both valves are...
  9. eserv

    B2400 hydrostatic problems

    Many, as in most dealers are scarred stiff to repair a hydrostat! Kubota sell many more new units than parts because the demand is much higher. Install the new hydro and be happy you don't have a JD! Ed
  10. eserv

    L3400 filters

    Maybe your friendly Kubota dealer? The hydraulic filter for your tractor is $23.92 at our dealership and the engine oil filter is $ 11.10. Ed
  11. eserv

    How long should it take?

    I'd guess about 6 hr's without a loader and 8 hr's with one. Ed
  12. eserv

    B6000 to buy or not?

    The B6000 doesn't have a waterpump. It will overheat if you push it to hard, after all it IS just 12.5 HP! Here is a sourse I found for a reverser but it isn't in the USA http://en.yenibiz.com/achat/produit_details_prod_561.html I'm sure your tractor is a domestic model from the pictures you...
  13. eserv

    Kubota B2410 Power Steering Problem

    Butch had the same problem with his B2410 about a year ago. You could look in the past posts to find how he resolved it. There is a kit from Kubota that redirects the return oil from the steering valve. Ed
  14. eserv

    just purchased a GR 2000

    Oh it's not a bad tractor! It just wasn't one of the best ideas! The rear axles did give a fair amount of grief, but if well looked after and not used rough thay can give good service. And they DO turn real sharp! Ed
  15. eserv

    B6000 to buy or not?

    That B6000 is probably not grey market and most parts are available for it from Kubota. Vic can probably get anything you would need for too, and probably cheaper than the Kubota dealer! My guess though, you will likely get years of faithful service from it with very few parts required. They are...
  16. eserv

    just purchased a GR 2000

    The GR2000 doesn't have a rear differential. It has clutches in the rear axle that disengage drive to the inside rear wheel in a turn, controlled by cables that go to the front axle to sense steering angle. I theory it should reduce tire skidding in a turn while still maintaining at least three...
  17. eserv

    L175 Valve adjustment

    Turn the engine either direction until one valve is just closing and the other is just opening on the cylinder you want to adjust the valves on. then turn the engine one complete turn(either direction) and then adjust the two valves for that cylinder. repeat for all the other cylinders. this way...
  18. eserv

    Need Help, M105S problems

    Are you running a orbital motor continuously like a sprayer pump or similar application? If so you MUST install a flow control or your Hydraulics will severely overheat. I have seem a few hydraulic pumps destroyed on M series tractors that way. The remote valves, couplers and associated hoses...
  19. eserv

    New tractor new noise

    A mechanic will have to split the tractor at the rear of the transmission to have a look . New tractor should be covered by warranty! ed
  20. eserv

    Grader or Scraper for BX25

    Quite an interesting earthmover and leveler are sold by http://www.gaenterprises.ca/ I'd like to here from anyone who has used one of these! ed