Search results

From the google pictures I could find both snowblowers look to be 1.5 auger turns. For performance if they are different maybe but i think other design differences would be more important and the engineer should have optimized the speed it turns at for that blower.

Here is what I have observed with my 2650 hydraulic fluid. I have checked it hot, cold, 3 point up, 3 point down, and front attachment is either on its stands (front broom) or on a 2 inch piece of wood/ foam block (blower). This is at 93hrs on the clock and I did what the owners manual said for...

One or two wires should work. The negitive wire just goes through the body of the bulb if its a one wire bulb.

Thats exactly what i thought but wanted to The big question is How is the light output compared to stock?

Remove the housing from the cab and there are 2 screws in the back. (If its the same light as the b2650) the bulb from the link above is a h3 35w. The thing that will be a pain is finding a led that is the equivalent lumans (or higher) as the 35w h3 and that fits in the housing. A 35w h3 has a...

My b2650 cab the height to the top of the fuel cap is about 51" with r3 turf tires.

Here is a link to MSC any of these reamers should work. Your ~measurement you gave and the numbers the service manual that was given by torch say you need a .275 to .2762 reamer. it's a simple process and can be done by hand with a hand reamer. But is easier with a drill press or a vertical...

As my dealer put it L is for loader work, M is for mowing and the white fluffy stuff when its not warm, and H is for highway. Mid range is what you will use most of the time. The low range with loader work is for when you are going into a pile stone, dirt, ect. I dont have loader so I am just...

I am pretty sure that in most UAVs you can change what the aircraft will do in the event of signal loss or gps loss. In the case of flying under a tree canopy I would disable RTH and land in place if needed.

After a little research it's made by Warren Distribution inc. They are the same company that does Amazon basics oil, MAG 1 oil and many more private lable companys. Here is a link to all the lables they make oil for if anyone is intrested...

Even without plugging breather when I removed the filter on my 2650 I lost about two quarts of fluid (i was attempting the vacuum trick but it failed). If you have a new drain pan or one that will not contamate the fluid you could resuse it. If you are quick enough you will loose alot less fluid...

The owners manual says 400 hrs the work shop manual says 50 for the first hst oil change. When I did mine I did not do a full change just the filters. If I where to do it again I would change the hst oil at 50 hrs. My reasoning being when I took the hst filter off I lost about 2 quarts and the...

While I don't have that model tractor as long as the lights go out when the engine is running eveverything should be fine. I would think its just like a car with the key in the on position the battery and check engine light will come on until you start the engine. The battery light is basicly...

On our B2650 cab I calculated it used an average of just over 1/2 gal per hour to be exact .589 gph over the first 64hrs. The usage was just a front mount broom (~48hrs) and a snowblower (~16 hrs) not the most strenuous use but interesting to know. I should have seperated summer and winter rate...

Yes, you should see oil at the level check plug. As for oil recommendations follow the manual. if you decide to use a gear oil just remember that not all gear oils are yellow metal safe. a yellow metal is a copper, brass, or bronze metal. The gearbox you have is called a worm and wheel gearbox...

In the grease you listed it's right in the name its a lithium complex. On most greases you need to look at the data sheet or for example amsoil its listed in data bulletin as the thickener. In the safety data sheet one of the ingredients would say bentonite clay or clay something. If you can't...

Yes clay can be NLGI #2. The NLGI rating is the grade or the spec the grease has to meet or exceed. Clay is just the oil carrier also known as a soap. There are many different soaps common ones being clay, polyurea, aluminum, lithium, aluminum complex, and lithium complex. All of thease soaps...

From what I have found its a standard 1156 bulb. I am looking at going to led in my 2650 and am over researching led bulbs. Sent from my SM-N950U using Tapatalk

Re: B23650 black diesel exhaust Like everybody else said you most likely have snow/ice in the airfilter. Once you remove it and dry the filter you should be good to go. Removing the intake tube goining to the air filter will prevent the snow from being sucked in. You just need to remember to...

I have watched the snow slide on top of the ground. When i watched it it was caused by the giant auger gearbox up front once snow starts building up on the gearbox its a snowball effect. Literally. For the bogging down issue check the airfilter for snow and ice. If you have not already removed...