Search results

I'm guessing he is working on the principle how a wheel on a vehicle can start to wobble at 55MPH and disappear a 60 or one can play a sound by rubbing the rim of a glass of water at a certain speed It may help to slacken the frame bolts and then re tighten them. Dave

problem on ott or all url's? If on BB have you been to one of the speed checking sites?..I could be there is some sort of a problem in your area.If you use IE,try one of the faster browsers like google Chrome, firefox or opera. if connecting to your router wirelesely connect with a LAN cable...

Have you tried adjusting the control rod upper stop to make the arms lift higher? page 27 of the owners manual, dave

To operate your backhoe you will need a 6 spool control valve,2 will be uses for the right and left stabalizer legs each with its own lever,one pair for slew and dibber .the other pair for curling the bucket and operating the boom.I mention them in pairs because you say you wanted two stick...

You can make things easier for yourself by jacking up the rear of the mower until the top link pins become loose enough to pull out. When you get the link off make sure each of the threaded parts are screwed in equal distances into the turn buckle ,about 4 turns or however many turns that equate...

What model tractor and mower do you have? dave

If tightening the rocker bolts stops the engine from starting then its probably compressing the valves because the decompression lever/cable is frozen or not properly adjusted. Just make sure the decompression button is fully in and there is a little free play on the lever on the rocker cover...

I use" ie spell" for a spell check,when I remember to use it. http://www.iespell.com/ dave

I'm with you on this "a grumpy old fart" ;):D While I am a great fan of technology,Social networking sites are a cheap way of gathering personal information that one day could come back to haunt one..all in my own opinion of course as I said in one of my very early posts. Dave

Its a little unusual,most would be proud and not want to hide the fact its a Kubota,Did the original owner paint the tractor or was it done by a third party selling it? Is that front box section full of concrete to add weight? Dave

Well I can help you with the wooden block,it was stuck to the bottom of the toolbox right at the back of it and was the only thing in there except for an oily rag which I don't think was original!:D dave

Just an update on this to confuse matters, the dipstick measurement I gave you had a part nunber of: 15371 36411 off 1978 tractor I have just measured the stick on my other B7100 1985 tractor , the part number is: 15371 36412 and the full mark is 10mm lower.the low level marks are the same. The...

102.72mm from underside of rubber stop to full mark dave

What grade of oil is this Traveller Universal stuff? the front axle and gearbox takes 80/90weight oil in my b7100 which is the same as your B7001. That pto seal is the least of your worries and if you decide to fix first I would not advise driving around doing more damage until you've looked...

Ive used a four wheeled/tine version of these quite a bit,we call them an "acrobat" turner. They roll the grass up into a long coil and are ok if you can row in long straight runs but turns and going around obsticles can get messy and you still have to pick it up! I would much prefer the...

If you have a look at the parts diagram,you will more then likely find the problem in that area ,if your very very lucky,just the pinch bolt could need tightening or if not the shaft or lift arm spline has gone. 12 is the shaft,15 and 16 are the respective lift arms dave

Diagnosis is reasonably straight forward if one starts at the begining with known or proven facts and works through eliminating posible causes on the way, then there is no need to wonder if "this has been changed"or "is this blocked"..Once bad fuel is mentioned I would not mess around with...

How deep is the water in a paddy field?! Dave

If the fuel level in the tank is higher than the pump then gravity does the job!If the tank level is lower then a pump is required. I am not familiar with your tractor so you have to make that decision. You could also search for "bleeding fuel lines" or look in the video section as there is...

Its very unlikely but to eliminate possible engine seizure,check your oil level is ok. Have you bled the line all the way from the tank to the low presure side of the fuel pump? you don't normally need to turn the engine over for this. Once fuel is running freely from there you can start...