Search results

"Generally", solenoids have 2 circuits, a pull in and a hold in, pull in draws high current, hold in low current, are switched by 2 separate circuits, and may have a internal switch or resistor in the pull in coil. However, the internal circuit is not always shown, so a solenoid that has both...

Same thing happens in all gears? Have you over adjusted the clutch by any chance?

So the globes test ok? I haven't downloaded but I expect a diagram may be in the WSM here http://www.kubotabooks.com/AutoIndex/index.php?dir=Tractor%20Owners%20Manuals/

A dynamo is a permanent magnet, AC generator, you have one under the fan pulley, the AC needs to be rectified to DC via a rectifier, then controlled via a regulator, (depending on model), or by a combination rectifier/regulator. Permanent magnet dynamos have low output, so replacement...

If only it was 1 minute per post? A lot of his replies are very detailed and even if he was a proficient typist/cutter/paster, I expect he spends a lot more time here helping anybody/everybody. THANKS!

Use of tractors in cleaning of chicken/turkey sheds means a build up of bird excrement dust on top of everything which then corrodes, it looks like corrosion has started on the top of your pins, but may have been from the salty environment you mentioned. Lack of lube is also very evident. My...

Easy to let out of the wires, but oh so hard to put back! And I've seen a lot of it come out over the years!

Joystick rod ends are available, go to http://www.kubota.com/part/partsList.aspx and agree to terms an put in your loader number and look at the list of parts and diagrams. I haven't had a look, but bushes may or may not be available from kubota depending on model, and may need to be sourced by...

Depending on model, possibly expect a regulator replacement and some of this.........

To me, the timing marks look good, they will be out of whack once the engine is rotated due to the different ratios of the gears and will come into line again after "X" rotations. I would remove the glow plug rail and plugs and check each individual glow plug across 12 volts to ensure a...

Did you glean any more info on this or make a purchase?

400+ page manual here http://www.gbfoot.co.uk/downloadfolder/KubotaRTV900.pdf

One other thing to consider, the grade of the nut you buy from different sources, I would be looking for a grade 8.8 minimum. YMMV.

I don't know the answer but I do own one of these thread pitch gauges which is very handy. https://www.amazon.com/Grip-Thread-Pitch-Gauge-SAE/dp/B004ROIU2A Generally the studs will have COARSE thread pitch where they screw into the head and FINE thread pitch for the nuts. So if they are 8mm...

Last week I bid on a kubota powered genset D1703 with 16600 hours on it and wasn't concerned.

Perhaps this is a late model with automatic temperature controlled glow plug cycle?

It certainly sounds like the battery, so either use the charger again, and if it starts right up, it's the battery, or use a booster battery and cables and if the same result, then it's the battery. It's also possible something is draining the battery down, or it's just starting to fail. Get a...

If it is the valve, have a look at the parts layout diagrams at http://www.kubota.com/part/partsList.aspx as well as youtube

Only problem is that he is asking if the RCK60B-22BX will fit the BX2370, not a BX2200

Nice work, hopefully you'll be able to address the finish cutter and catch up in the end.