Search results

  1. B

    What grease is recommended for my implements and other asst zerk fittings?

    I have to use grease rated for -20C or my pedal freezes in the winter and the tractor won't start until I fiddle with the pedal.
  2. B

    Help with BX hood staying open

    The tab acts as a stop at the slot.
  3. B

    Help with BX hood staying open

    It goes through a slot in the bracket on my bx2370.
  4. B

    Bx2380 Block Heater remove/replace

    ebay has this one...
  5. B

    BX25D block heater removal and replace

    I went through a couple of these heaters before adding a timer and now it seems to last. I remotely turn the heater on from inside the house, it's on for twenty minutes and off for five and so on. I think the space is so small around the heater they get hot and burn out when left on too long.
  6. B

    BX25D block heater removal and replace

    This is the type of heater on my BX2370. To remove it I use a female coupling screwed to a threaded pipe from a pipe clamp, use a couple of round weights on the pipe with a coupling and washers to keep the weights on the bar. Thread the coupling attached to the bar onto the heater and use the...
  7. B

    3 point hitch travel on bx2370

    That's what I thought Russell, just checking on here to see if anyone had made that adjustment. Thanks for the response.
  8. B

    3 point hitch travel on bx2370

    Ok, thanks for the replies.
  9. B

    3 point hitch travel on bx2370

    How is the up travel adjusted on the hydraulic 3 point hitch? I'd like the up travel to stop a little lower.
  10. B

    Ignition Switch Ring / Nut for 7500

    nut for ignition switch for sale | eBay
  11. B

    55 hours on BX1870 and overheating

    If the fan is spinning, I can't see it being the fan belt as your problem.
  12. B

    Blown head gasket

    Can you use two head gaskets?
  13. B

    BX tractor bracket stopper

    Ok, that explains it. The top link on my tractor is always in use, when I put on a larger top link the bracket was left off because it no longer fit. Thanks for the replies.
  14. B

    BX tractor bracket stopper

    What purpose does the bracket stopper serve?
  15. B

    Back dragging with a front snowblower ?!

    I back drag the 2750 in order to pull snow over patches of bare ground . I also plow small amounts of snow with it short distances to an area where I can blow it.
  16. B

    Fuel issue

    You might have sucked up some water .
  17. B

    BX23s ignition bent

    Did you try de-icing it prior to damaging it?
  18. B

    Wire Connector

    Depends on the current and the wire size.
  19. B

    RTV1120 heater

    I have this one for sale, good heater but my bx only has a 40 amp alternator. Heater Dimensions: 6”x 5” X 4” 12 Volt, 50 Amps, 600 Watts 10,020 BTU’s Brushless 50,000 Hour Ball Bearing Fan 10,000 Hour DC Thermal ©RuCar Vacuum Sealed Elements. Case Construction: T5052 Aircraft Aluminum. Wired...
  20. B

    Heat control

    I bought these valves and changed the fittings to npt and eliminated the rubber washers.