Search results

Up this way they say " Two seasons, Shoving & Swatting"

YES! I just bought a new JD Mower an X380 and got a cap. NO way would I wear in the Orange unit.

If its not a float switch, I'd look at the Contactor for the Evap fan, i.e bad or weak coil which holds in the contactors

Where it the Evap.Unit locataed? If in the attic or above a ceiling the Drain pan my be clogged/ slow draining and it could have a float switch locking out the blower.

Or use rubber buckshot :)

I was one of them broken into up on the Tug about 10 years ago at my old camp. Smashed in the front door and ransacked the cabin and busted into the 20' container. Mostly took stupid stuff and no real damage other them a broken door and the container lock /hinge. But I was PISSED OFF..... If I...

It's about being level. I made the mistake of dropping it in an awkward place on gravel once, never a again. Now always in the garage on concrete with good lighting to get it aligned with the sub-frame.

What he said! All so a couple of jack stands will keep it off the ground when dismounted.

Since the rain has stopped, I've filled a 30 Yard dumpster with debris from the project property we bought. Also moved about 5 or 6 Tons of scrap steel getting ready to load out to a scrap dumpster. Gotha love Hoarders!

At minimum I would bock it up on the dolly and strap it down and do a wet Compression test. I know id sleep better knowing its good to swap out. Just saying.

What are you hauling on it? It may depend.

Found this today, just down the road. https://constablevilleauction.hibid.com/catalog/170603/kubota-and-surplus-utility-and-farm-equipment-parts/

After 5 hours Brushing in the new seat all I can say it is AWSOME! No more sliding around, great back support and armrests, WOOP,WOOP. The best upgrade to date on the "B"

I had to Fab up a plate to match the OME mounting holes on the hinges and to bolt the new seat on to. This allowed me to keep the Dead Man and the Rear PTO switches in operation. Overall a great and comfy seat, big up grade from the stocker seat.

X3 on an Air-Less, I bought one about 20 years ago and use it all the time. I've shot Latex Paint and stains as well as Enamel on a couple of storage containers. I will say some times it takes longer to clean it up than the Paint job takes to get done.

I've never seen one, but as an OLD Boiler Operator please be careful with that little unit. make sure that a new and tested pressure relief valve is installed in the correct place in your piping. I wouldn't push the operating PSI over about 8 or 9 PISG on the loop. Good luck with your project...

I have an Stihl MS 192 with a 14" bar, I can't say any thing bad about this saw. Lite, great on gas and oil, plenty of power. I only use it for brushing out the bigger stuff and smaller trees up about 10", after that the Farm Boss 20" comes out. Overall its been bullet proof over the last 8 or 9...

We have a couple hundred of them on the top of 'The Hill", they do make noise and vibration if your close enough to them to feel it. with more on the way. I had a Camp up where they were built in I could hear them at night when the wind was blowing the right way. I was 4 miles to the closest...

Try Jacks Small Engine on line found the carb I needed for an old Briggs vanguard motor on an old chipper I had.