Search results

Operators manual specifically tells not to reverse front or rear rims on a BX tractor as the wheel can not stay tight to axle hub.

A lot of Ford V8 engines also use 2 drain plugs.

Thank you, Have a safe and Happy New Year!!

If you put the Positive ring on the starter stud with the battery cable you will not have the possibility of corrosion that you do when mounting on the battery end. Most all battery cables will carry the load of the tender.

Good choice!!!!!!

Yes, we are busy with our Winter Service Special going on. Its surprising how much orange paint there is out there. :) Sales has been pretty steady also, this month they sold 4 SVL,s, some L's,some M's, severial BX's, a lot of attachments, used exavator etc. Safe and Happy New Year to you also!!

Is it as good of filter as the Kubota filter? Is it a proven substitute? Will it perform in severe cold weather startups? Does Fram recommend and guarantee this filter for this application? How do you know? Is it because it screws on? How do you figure that a person could possibly save any...

You did put oil in the pump before you installed the pressure tubes didn't you? If not, take the tube back off of the top of your pump, put some oil in it so it came create a vacuum to suck oil up to and thru the filter.

Set up and PDI is done by the Setup department, not the Service department.

Actually, I just jumped our Envoy XL with my BX2370 this weekend. Battery is only a little over six years old, wind chill was -22F, had not been started for 7 months and that darn thing would not start. :D Bx, cables, 5 minutes and shes running..

With the detent ball and spring removed, fork should slid on the shaft freely.

You also have a Seat Turn Switch that is under a cover behind the seat IIRC. It will also shut engine down when clutch is engaged I believe. Have not serviced an L39 for several years.

Your code is telling you the engine will not crank because of a failure. Did you check to see if you have more than one code? To load an inoperable track loader you remove the cover from both left and right planetarys. Next you pull out the sun gear from each side and reinstall covers...

With out being in the seat and pressing on hydro pedal, tractor should die in 1 to 2 seconds. The hydro switch is just ahead of the left rear axle housing, try adjusting it in 1 to 1/2 turns. See if that changes the problem.

"Could" cause internal engine damage. Huge difference.

Never try to teach a pig to sing. It just wastes your time and annoys the pig.

I was just thinking that some evening I would have to drive by and see what you were using for a gate that needed a post like that or if you just like to over build. :D

Have you checked your fuses yet?

Seal should be installed with the garter spring toward the hydraulic pump.

That is one massive gate post!!!! :D