Search results

L3130 Just changed front axel oil switched to 80-90 gear oil drained a little from both sides when changing motor oil for a look see {Struck gold} changed front axel oil at 1000hr serv. used udt 2 did not strike gold at that service time . Don't know what oil was in it then as I just got it. Had...

Nice old men handle. Was thinking about making one also. [ Because i am ]

New addition to the hunting party

I would drill new holes 180% from old & weld up old holes. [ the slop the better] my 2 cents

Just use 50/50 as is unless you live in the way north were temps jet sub "0" then straight antifreeze. Some will argue some ratio of water anti. at sub temps. my two cents cant go wrong with straight in sub temps.

Need a hydraulic press / Need to disassemble cylinder so you damage end cap or packing gland assembly / a 20 ton should be enough / also need "V" blocks to hold / also when pressing shaft need to go past straight a little bit / also use a good steel yard stick to check

Geo i have a ferguson to20 for parts i am running another to20 for mowing but will part with parts like that PM me if interested will talk on the phone

Quarter inch plate 1 inch key stock is spacers. UHMW plastic just dropped right in.

Tractor plu is correct you have to sell your self first dosn't matter what your selling / If the Customer dosn't trust or like you IT DOSE NOT MATTER HOW GOOD THE PRODUCT / YOU'VE LOST THE SAIL

Not sure the pto hp on you tractor? I run a 72" Behind my old TO 20 Ferguson they are only 20 hp engine hp

ducktape just rep some around oil filter wrench in a cople of spots just the size of the notches on the nut

Daferris is correct home heating fuel oil and diesel are the same

Have a skid steer attechment depot 72" duel cylinder root rake grapple 600lb on my L3130 / If i had to buy one agen i get a 60" or 66" Not because of WT "Might" be juse a little easer to maneuver arround & get in to places (Tractor has 72" bucket)

R What is the SSQA Plate your talking about ? Just Curious ? I have a bit of problum the other way hard to get pins into slots on bucket not so much on my grapple Thanks (Picture maybe?)

It has It has a T E F C moter on it put it outside in a (outhouse Enclosure) No Noise in the shop & safe if it blowes

Bought a pack of 10 - 5 male 5 female less thin 10 bucks on Eday all black not as strong as O.E.M. but work fine

THANKS

NICE ?? Were did you get the threaded funnel ??

Had my L3130 split to change HST trans. There not much involved only a sliding spline coupling , there is a bushing were the shaft goes into the trans. go under & see if you can move the shaft left &righ up down to see if that bushing is going bad.