Search results

Thanks for the advice . I finally have a copy of the wsm so hopefully I can tackle this job myself.

Definetly not the oil pan. Where’s the front seal again remind me

It appears as it’s leaking from above the pan behind but a little below the flywheel. I can’t tell if it’s a bearing or what

Will be upgrading my pan and gaskets and going to fab a heavier skid plate for my unit . Yay

Yeah, after 50 hours fluid and filter changes for a new machine . But he stated his was a 2009, so changing your oil and filters after 50 hours is likely a waste of money IF there are maintenance records and documentation is proper. I agree with you partially too :D

You can see the oil stains but the actual leak is coming from the front bolts

I don’t know what the cost would be like but shell s4 txm is compatible with kubotas UDT standards. I’m sure there are a few out there you just have to research. Hopefully you get it resolved before dumping 3-400$ worth of udt in your tank.

Would 303 contaminate the system ? Should it need a flush ?

Every 250 hours for engine oil Every 500 hours for TXM oil Grease every 10-15 hours. I usually do 2 pumps per grease nipple

My 1120 is a bit sluggish , but it always has been. Tranny oil has only been changed once as it has just over 500 hours on it. If you wanted something faster you should have got a razor

Well I checked the oil pan and it’s dripping from one of the screws on there , more towards the front of the block. So I’m thinking that this thing really doesn’t like the cold. I have started it a few times and it’s been rough. I wouldn’t think oil pressure could make an oil pan leak. Normal...

I needed this like I needed a hole in the head. My machine only has 580 hours.

I generally clean my water evap and other fuel components with kerosene. I don’t recommended running kerosene in your machine as you could potentially damage seals but a light cleaning wouldn’t hurt . Sounds like it could be a line , I don’t think I’ve had a filter really plug .

MY bucket and grapple aren’t having any issues

My m100x seems to lower when you lift it and I’ve checked the seals on the lift , and checked for any sweats and haven’t found much. My hst and other hydraulic filters were changed about 200 hours ago . Any ideas

I'm looking for aftermarket cab for my diesel rtv. I got a few quotes from a few different places and most were around 4800 to 5000 CDN. pretty steep. Anyone recommend other options or places to buy used

X1120d No worries, I didn’t specify

My 1120D is needing some move as my skid plate has decided to eat itself lol. The plate closer to the rear wheels is bent and instead of trying to bend it back I decided to do some research on skid plates or make one and fit it on. Anyone have any skid plate mods ?? The OEM skid plate is a pain...

427 Shelby cobra ?

Anyone here fabricate their own single hay bale trailers for pickup use or kubota side by side? I’ve seen a few ideas searching the net just getting an idea here. Thanks