My m100x seems to lower when you lift it and I’ve checked the seals on the lift , and checked for any sweats and haven’t found much. My hst and other hydraulic filters were changed about 200 hours ago . Any ideas
Hydraulic issue
- Thread starter OlFerguson
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Could be the feedback linkage is out of adjustment.
I would get the WSM and check it out.
Another option:
Does it have draft control?
That being activated will cause the three point to act erratic.
On Further investigation: That model has an internal lift cylinder, How did you check the seals on the lift piston?
I would get the WSM and check it out.
Another option:
Does it have draft control?
That being activated will cause the three point to act erratic.
On Further investigation: That model has an internal lift cylinder, How did you check the seals on the lift piston?
Last edited: