Search results

Collars, bearings etc. you may to consider pricing the entire spindle assembly, there's been cases where it's more cost effective and less downtime.

Not sure if this will help, but most generators speed sensors that are mounted so as to count pluses from crankshaft i.e. the starter ring gear, the pluses are sent to a electronic control unit which sends a signal to the governor actuator which in turn increases or decreases the throttle to...

Are you trying to press both the bearing and collar at the same time? First attempt to use a bearing splitter between the bearing and collar then press just the collar, if successful then press the beating off or just cut the bearing. If you don't have a splitter, cut the bearing which will give...

I gather from your description the spindle 8, bearing 9 and collar 10 is in your hand, in other words out of the housing, or is that assembly still in the housing? In the first scenario I'd suggest trying to get a bearing splitter between the collar and bearing trying pressing just that piece...

I like liquid filled rear tires, it doesn't add weight to the tractor only the tires.

It shouldn't matter weather you have forks, bucket or grapple. the joy stick should give you up, down, curl and dump. Confirm that the lines are correctly orientated. Who installed the 3rd function?

It's your money! Play one dealer against the other to get your best deal In the end you're the one that needs to be happy.

In 1985 two posts lifts were the stuff of dreams, I only paid $200.00 for two (11,000#) inground lifts which needed repairs. It's still working good, gave the other one away.

+1

I recommend getting the old head off, so the head and cylinders can be thoroughly checked then formulate a plan.

Four years and how many hours? Was the engine running hot? I would be good to have the head checked. As always check your manual. I don't believe they need to be re-torqued, it certainly wouldn't hurt to replace the head bolts with new from Kubota. Use a thread restorer and clean the bolt holes...

Good luck and keep the posts coming.

I went from a 6 foot Gravely ZTR with the 25HP Kubota back to a Ford 4000 with a 7 foot finishing mower. I enjoy going a little slower with out all of the bounce.

Can't help on sizing the filter. I'm curious on what's to gain by adding an oil cooler? Are the taps in the block to attach the coolant lines?

Somethings causing more heat then the cooling system can dissipate. You're looking for a representative temperature. You still haven't told us what the "warm" temperature is. I believe you have four points to drain the system. Note the condition and smell of the removed fluid. If the previous...

Looks like a fun project.

Give it a little TLC and enjoy the ride. Congratulations

"Very well maintained and cared for" What caused the head gasket to fail, overheating, failed component? How long has the tractor sat with coolant in the engine, hopefully no ring or bearing damage? Once the head is removed it needs to be checked for cracks , damaged valves/seats, flatness...

Never happens at a good time. Although, I need to ask, what purpose does the road serve?