Search results

Price drop.

Price drop again.

Dropped price.

Hi- I have a set of barely used Titan Attachments 48” clamp-on debris forks. Nothing wrong with them, just don’t need them. They weigh in at around 120 pounds and stated capacity is 2,500 pounds. I’m asking SOLD for these. I’m located eastern Vermont. Please PM if interested. Thanks!

Thanks. I mean, I think that's what I'll end up doing, but wondering if there were any 'gotcha's' that I should watch out for. The work itself seems very straightforward.

Parts should be here on Weds. Is there anything I should do after I put on the new banjo bolt and bleed screw? Just run the fuel pump? Thanks for the help!

Ok, I think I've ruled residual diesel in the engine compartment. Got up this morning and there was about 1 cup of diesel in the pan I set out last night (around 9pm). That said, I think (hope!) that I've narrowed the leaking diesel down to the component that is adjacent to the injection...

Fair question. I replaced the fuel pump, under the tractor. Figured I needed to get any air out of the system...

Broke clean off at the casting. Think I’m going to order new parts -they aren’t expensive and probably/hopefully less headache than trying to extract the screw. The dripping diesel doesn’t seem to be coming from the inlet, where the screw is broken off. Actually seems to be dripping from...

Hi- As the subject indicates, I accidentally over-torqued the fuel bleed screw on my BX1860. I haven’t looked to see how difficult it is to replace this (or expensive), but it looks fairly straightforward. I pinched off the fuel line that comes from the filter into the assembly, which this...

Ok, interesting. I've only ever noticed fluid when it's warm out and I'm working the tractor in 4wd. 2wd doesn't seem to cause any seepage.

Ok, yes, they do feel the same when the tractor isn’t running. I may get a short section of hose made up to test these - it would put my mind at ease.

OK, PM sent back.

Hi- A few month's ago I installed the rear remote package on my Kubota BX1860. I plan to get a hydraulic top-link for driveway maintenance in the near future, but at this point haven't really had the chance or ability to test these. I did move the levers back and forth after install and have...

Price drop.

Ok, thanks. Do you put the plug back in after pulling it? Do you seat it fully or let it rest in the fill hole?

Ok, checked these items, as you suggested, and battery is good. I didn’t think this was the problem as I put in a new battery last fall, but never hurts to check. Also the voltage is almost identical at the pump, so I think I’m ruling out the electrical. I think I’ll order up a new pump to...

Hi- I have several work lights and ROPS mounts for sale. I purchased these thinking I would use them, but just haven't, so letting them go. 1) New Kubota BX rear work light kit, which includes the light (LED bulb), ROPS bracket to attach the light to the ROPS, and wiring to wire into pigtail...

That I can do - I have a multimeter, which I don't use all that often, but purchased just in case. So should be 12v at the pump correct? If I do find the voltage is low, should I then trace back using the multimeter until I find the drop? Thanks!

I think I’m just being paranoid.