Search results

Hello Don. I said there was 7 bolts I went out and looked at a tractor and it's a total of 8 bolts. Lance

Hello Don Did you remove 7 bolts from the lower cover. You have 3 nuts on a small cover on the left bottom with the PTO shift pattern on it that you do not need to remove. You do have one bolt in that cover that you will need to remove. Good Luck Lance

Hello If you bought your tractor in 1977 I am sure your tractor needed the kit . Serial number 54975 and above has the new type cir clips . Part # 35340-21782 is the new type cir clip and Part # 35340-21792 is the lock wire that goes with it. It takes 2 each. You remove the shift lever cover...

Hello First question is will that washer fit through the drain hole. If it will not it did not come out of the transmission. If it has blue paint on it it did not come out of the transmission. There is nothing inside of the transmission that would be painted blue. Did you ever have a update...

Hello Looks like sealing washer off the drain plug. That will not fit through the drain hole will it? Lance

Hello I just replaced the complete rear axle housing on a BX 2200. The brakes are the last thing in the rear end housing. It's going to require complete disassembly of the rear end housing. As stated above the complete rear end assembly will have to be removed from the frame rails. I had over 20...

Hello Always check transmission oil with three point down. If you have a loader lower it also. Good Luck Lance

Hello I have a used cap if you still need one. Send me a PM if you're interested in it. Thank You Lance

Thanks D2 Yes I have plenty of L245 seat suspensions .I have new , rebuilt and used. Lance

Hello This is not a real hard job. A service manual would help. If you look at the parts brake down it will help you see what you are dealing with. Once the tire and fender are off it will be pretty straight forward.Drain the oil ,remove the brake linkage unbolt and remove the axle. Put the...

Hello I have the Handel you are looking for. Send me a PM if you still need one. Thank you Lance

Hello My experience has shown 99% of the time it is the fuel lift pump. If you have access to a handheld vacuum pump you can check the pump very easily. You can do it on or off the machine. Remove the fuel lines from the fuel pump apply vacuum to one side plug the other side and it should hold...

Hello I use a pair of Harbor freight Long needle nose with 45° tips on them. Warm up the fuel line before you try and to put it on. It's not easy but it can be done. Also replaced the hose clamp with a number #4 mini that you can tighten with a socket and not a screw driver. If you send...

Hello I think if you look closely at the material you will find it is brake lining. I would drain the oil and remove the suction line from the side of the rear axle house right-hand side. This is the large line that leads to the cleanable filter on the right side of the engine. I think...

Hello Yes I did. Did you get a response from me. It sounds like you did not. I'm sorry. I'll send it again. Thank you Lance

Hello I have the gear you're looking for. If you still need it send me a PM with your email and I'll get back to you. Thank you. Lance

Hello One other thing you may want to check first is the relief valve in the oil filter housing. This can sometimes get trash in it causing low oil pressure. Good luck Lance

Hello The first thing to check is to be sure the brake levers are not froze up . These are the arms on the outside of the brake housing. They sometimes get rust on them and get tight in the housing.This is a very common problem with the L245DT. You can spray PB plaster on the lever so it runs...

Hello Bill Just wondering what part of Northern California you're in. I don't see many post from fellow Northern Californians. Lance

Hello I have a steering box for a L275DT .Send me a PM if you are interested . Thank You Lance