Search results

Hello Did you have a any problem before you ran it out of fuel ? Did you bleed it at the top of the injection pump or at the injectors ? Lance

Hello The first thing I would check is your Remote Hydraulic levers. Be sure one is not stuck in the on position. This will heat the oil up Real quick. Good luck Lance

John I always remove the drive shaft. Just remove the snap rings and slide the front and rear splined coupler onto the shaft. Then you know it’s not giving you problems. Lance

Hello John You are correct. The hub goes to the transmission side. Do you have the clutch linkage lose so the release bearing is not touching the pressure plate ? What are you using as a pilot tool ? I use two long metric bolts with the heads cut off as guides. I put the transmission in...

Hello. The inlet to your valve is the hose on the left side of the valve in your first picture. Return line is closest to the loader frame. Good luck. Lance

Hello These tractors and Normallyreferred to as harvest rentals. They are owned by Kubota. After rental they are transferred to different dealers for sale. They are normally sold with A full factory warranty. I would not hesitate a bit to buy one of these tractors. I work on a lot of...

Hello I use a small amount of grease. Good Luck Lance

Hello Sammy Have you checked the hydraulic filter. Lance

Hello Your filter is located on the right side of the engine near the hydraulic pump. You will see a canister with a plate on the bottom with three bolts. Good Luck Lance

Hello Ty I do not have a engine or parts for your L5030. I do have lots of older Kubota parts. Thank you Lance

Hello You will need to remove the front axle support to remove the pulley. Remove the tie rod from the steering box, unhook the head light wires and the positive battery cable. Support the engine unbolt the axle support from the engine and roll it forward. Then do as Daren says. The pulley is...

Hello I can make you a set of hoses and ship them to you. If you have a Kubota Loader I know the sizes. Send me a PM and I can get you a quote for completion set. Thank you Lance

Hello The first thing I would check is the vent . If the vent is plugged up it would push oil out this area as well as around the shift levers. It is an usual to see oil leaking from this area. Good Luck Lance

Hello I have moved many tractors over the years with the canopies. I Have always backed them on the trailer and never had a problem. Good Luck Lance

Hello I have the parts you are looking for . Send me a PM . I am in central California. Thank you Lance

Hello Sammy You are correct. Good Luck Lance

Hello Sammy Looks like you’re old transmission is missing a small piece. What took place. Do you have a loader on this tractor ? Lance

Hello Sammy You should not have to remove the large nut. The steering box is bolted to the top of the transmission with four bolts just remove the 4 bolts and remove the complete assembly. The four bolts come in from the top. Good luck Lance

Hello Sam. I think maybe the one thing that might be confusing is the seal is of a different style than the original. It looks like you have the outer edge of the seal flush with the housing. The important thing is to be sure it's even all the way around. The seal is riding on a wear ring that...

Hello As Russell stated the petcock can be rebuilt. If it is not leaking where it screws into the tank no need to remove it. Just remove the snap ring on the face of it and screw the valve out. Just one oring to replace and it's available from Kubota. You can remove the complete petcock from...