lmichael's latest activity
-
Llmichael replied to the thread Stripped Starter Bolt on Kubota TG1860.Honestly IIRC both of my (what you call "receiving bolts") basically welded nuts on mine were welded to the plate and you only needed to...
-
Llmichael replied to the thread Stripped Starter Bolt on Kubota TG1860.That looks more like the weld nut. That shouldn't be turning anyway. IIRC it's welded to the back side. I don't recall having to deal...
-
Llmichael reacted to North Idaho Wolfman's post in the thread B2320hsd (d1005) engine stop solenoid replacement caused engine to rev to top rpm with
Like.
How did you determine the solenoid was bad? How did you determine which solenoid you should use? Where did you get the solenoid? What... -
Llmichael replied to the thread B2320hsd (d1005) engine stop solenoid replacement caused engine to rev to top rpm.Was it revving to max? I get the solenoid needing replacement due to not "stopping" the engine. Which we all have to assume is why you...
-
Llmichael replied to the thread Oil Capacity.My G2160 with D782 is spot on to manual.
-
Llmichael replied to the thread B2320hsd (d1005) engine stop solenoid replacement caused engine to rev to top rpm.Well if it was fine prior and not now, go back to step one and put it back the way it was. Work out from there
-
LFYI, most float specs (if you do not have an actual measurement to use) is the have the float parallel to the carb gasket surface when...
-
LJust wanted to finish up this thread- I took it apart AGAIN and found that the float metal "hinge" was just slightly bent. I carefully...
-
LDipstick tells the truth........ most of the time! Butttttt............. the dipstick CAN lie too - the little rubber stopper can move...
-
LI just want to follow up on this, if anyone else is interested. I re-adjusted the float level, and it solved the problem! Thanks, Steve
-
LThank You
-
LMost likely the glow controller has gone south. Don't run it with the plugs energized. You can unplug the relay until you get a new...
-
LPurple dye is cheap and can be added to any oil. I buy 80/90 gear oil in 5 gal buckets for some construction equipt I own.… So I also...
-
LExcept I at least get the benefit of weapons-grade diarrhea from the McDonalds. Synthetic gear oil in a mower deck that gets changed...
-
LIt doesn't cost that much more to go first class. Cheaper then lunch at Mcdonalds