Search results

Here it is

I'm thinking about putting my L2900 DT GST tractor for sale.i resently put a new head and piston and rings.its running but definitely needs engine work.the 4x4 doesn't work do to broken pinion shaft.the hydraulics all work good and GST works good.has the LA 480 loader on it.and it all works good...

It starts like it is sopose to now.and my tractor temperature gauge ain't right.onlt barely moves off cold mark.and only on the first mark when over heated.which temperature sensor works gauge.mine has two on it.one by thermostat housing.and one towards back of head.

I shut it off to move stuff out of the way.and you could here the water kinda bubling a little.i had my brother to pull it to my house.i tryed starting it up and started right up.shut it off and tryed it again.cranked over like suppose to.it don't make sense to me.with my luck I don't think I'm...

Leaked a little coolant out.but still is close to radiator full mark.

Yep both is full.just rensently put on new oil in it.

Te

Tractor got a little hot.so I shut it off.and now when cranking the motor drags and not crank fast enough to start.

Replaced the two o rings.the bottom one was pretty flat.so far no leaks.on the plate that holds stuff down.are they sopose to be flat? Mine isn't it's kinda bent.

Would this cause the hydraulic fluid to pour out at a pretty steady stream.leaked a bunch out.

It's coming from under the 070 part number.

My loader is leaking at the plate that has two hex bolts.its where the the handle pushes and raises the valve.my guess it has o rings.what all seals this from leaking and what's inside there.

From researching it's a king kitter with floating top link bracket.

On the top link a standard category 1 pin was to short the way it was when bought it.acording to what I can tell this piece pictured is suppose to raise up and the frame supports fasten with one big bolt.how exactly should it go?

One i seen for sale is made just like that.but yellow and asking $650.00 for it.is that to much for it?.

Does it work in Kubota ok.

Not many places in this area to get hydraulic oil.just got a Napa and TSC.becides a Walmart and Auto Zone and O'Reilly's parts stores.

I know many probably done asked before.TSC had the Shell Rottella HD that's says for Kubota.it was $114.00 for 5 gallons.anything I can use that is somewhat cheaper and won't mess up anything.

How much HP do they take to run them.and how heavy are they.would my L2900 operate it.

I took off the number one injector line from injector pump.opened the throttle wide open.turned engine clock wise by hand.but still don't see fuel spilling over out of injector pump.also didn't see marks on flywheel.what am I doing wrong?