Search results

Anyone have first hand experience that can suggest one over the other for ease of use ? or suggesting a different manufacturer. Thanks https://tractorptolink.com/ https://www.tractoraddons.com/store/

When its time for me to replace my trans/hydraulic fluid and filters... 1) Is it alright to add a dye while its still under warranty ? 2) If its alright to use it, does someone have a specific brand of dye they prefer, and if so, why ? Thanks

Im working with an L2501. After going a couple of days without starting, it sounds like my battery is getting gradually weaker by the sound when cranking the engine over upon a cold start. My alternator belt had just a slight amount of slack, so I tightened it for the first time since I had it...

I have an issue with my hour/rpm cable not working. I called my dealer and they said it was out of warranty 18 days ago. I understand that they have to draw the line somewhere, but just curious if any of you have had experience where they cut you some slack on a warranty issue, recently after...

Its still under warranty. Has 165 hours. Cable is securely attached on the engine side of the cable. My question is, if I loosen the bonnet (just two bolts I believe), can I get enough room to reach my hand inside to see if cable is secure without removing the steering wheel and throttle grip ?

Thats what my local COOP suggested they could do for me this fall, and I like the concept but I have reservations. I have a small area of around 1.5 acres that I want to plant some clover and winter wheat in this fall. Again, they said they could mix, load, and then spread the fertilizer, lime...

Just wanted to mention a few words about my L2501 Hydrostatic. This tractor now has a little over 100 hours. I am very much impressed with all the functions of this tractor. The precision and power of the trans is amazing. Even with the R1 tires and turning with the 4wd engaged (which I dont...

I start the tractor, get up off the seat and engine dies like the pto is engaged but of course its not. Anything else I need to check before calling the dealer ?

Im wanting to know the diameter of a lift pin (part # 38187-71580) Thanks

There are two axle supports (front and rear) for the front axle assembly that hold the drive propeller shaft (See attached picture) that have to be greased. The front (or forward)axle support has a breather plug that you remove, then apply grease through zerk until grease comes through breather...

I have a new L2501 so Im not sure if it came with UDT2 or Super UDT, but my question is can I top off (mix) the standard (Kubota brand) UDT hydraulic fluid with whatever came in my new unit ?

What could be the options of noise caused from when the clutch is resting/released and not depressed, while the engine is running ? When I depress the clutch around 2 inches the noise is gone. The noise sounds very similar to that of a rattling, thin sheet of metal, but apparently its internal...

I have searched the web and cant find what Im looking for, which is a copy of the pre delivery inspection sheet. If anyone could attach a copy or link, I would appreciate it. Thanks

Well I just assumed (my mistake) that they checked everything prior to delivering the unit but they didnt check the tires for sure. Now my tires being the R-1s then they might have been contracted out to the local Farmers Coop but still... Anyway I thought that I would check the tire pressure to...

I hope that I dont jinks my new tractor by bragging on it but I really like it. I have 10 hours on it now and the more I operate it, the more I like it. In the past years Ive only owned older used tractors and most have served my purpose just fine, so Ive never had a new tractor in my life until...

I just had my new L2501 delivered a few days ago and I specifically told the salesman I wanted it painted (Barney & Friends) purple and well the dog-gone shows up orange. Yes Im just kidding, I love my new L2501 so far. I hope that I dont jinks my new tractor by bragging on it but I really...

Delivery wait time for L2501 This can be frustrating at times but Im sure it will be worth the wait. Its been two weeks since the dealer said he would order the tractor. Im curious how many of you have had to wait over two or three weeks to have your tractor delivered ??? Just curious if its...

Anyone else try these yet ? Im a big fan of Pats and havent purchased yet and so I have founds these Field Tuffs cheaper than Pats and was wanting to hear reviews before buying them. Also I once called Pats when I first received them and explained that I accidentally bent my spacer arm and...

I remember hearing from my dad and grandpa that old saying, dont put the cart ahead of the horse. I feel like Ive done exactly that. Here I have a plow with no tractor to pull it. I should be getting a tractor within a week or two but I feel like Ive gone against what they said. I hope they...

Just curious how many hours should be on the hour meter when a new tractor is delivered. Is it common to have a few hours on them ? What would you except or not except ? Thanks