Search results

Can you put longer pins and double shear the end of the pins and still connect from below

I welded my hooks to the large angle iron and bolted that large angle plate across the entire bucket top. Put hooks in line with the bucket arms.

We could use more electric vehicles on our well maintained grids?

I did not disconnect for mig welding the hooks to the bucket BUT for tig I always disconnect, I fried some motorcycle parts with the high frequency. BUT your newer tractor may have a lot more computer stuff than my older b7800. Not that hard to disconnect.

So kubota thinks you should put stress on your differential and axles to level your bucket?

with the correct tool the internals of the plug can be removed and you could solder and replace the wires without a new plug or harness

I made a spanner wrench, But it was not tight and a piece of leather on a channel locks would have done it. Loosen while still in tractor much easier. The piston seal I heat up in oil to about 200 degrees put on and put a hose clamp on it lightly till it cools. No special tools. And my tractor...

https://www.summitracing.com/parts/brg-014949 just one example

check for a street rod automotive u joint weld in place if necessary Speedway motor etc.

The expansion valve will sense a need for more cooling and it will safely flood the evaporator with refrigerant to increase cooling but also prevent flooding back to compressor. Did you evacuate the system before charging?

Do a search, they have at least 2 devices to remove the valve stem from outside and install from outside.

I use super glue and fast set spray. Then cover with black liquid tape

I was quoted $195 to $230 for cylinder rebuild and in the high desert So. California. I bought the kit fromvColeman Equipment, Inc. Online. My first attempt at rebuilding a Hyd cyl. for my b7800 worked out great. I bought two kits but just did one cylinder and so far no leaks either cylinder...

I am leaning toward a fuel issue

For cars and motorcycles this is the best choice, because this will reduce the chances to rusting out the steel cords

I just picked up a oldet kubota neglected for over 6 years, there are many plugs in several tires and holds air after sitting fir years

If the glow plug light fails you eill np longer have power to gp?

I filled my kobota with 80-90 mixed to full, not concerned

are gas and diesel pump differant, I believe they are.

I have lock and lube and the chinese take off both work equally well for me. Accept there are time times that neither will fit the situation. Must have 30 other attachment.