Search results

Is that a L35?

Glow plug controller died on mine a couple years ago. It was close to $100 for the oem part. The glow plugs worked again after that. It's under the plastic by the steering column on the right side.

Curious as to what brand solar charger you had?

Not quite beautiful, but always reliable 1998ish L35

I got a couple emails out to companies as well I'll let you know the results

While I can't offer any advice I'd sure appreciate it if you post results as to what you figure out with both projects, as they are both on my short list as well!

Just X1000. Because the tach numbers are single digits

Nice, I have been looking at those for my L35

Seems good today

I still get the floating blue banner on the bottom of the screen while using my iPad. subject matter of best oil and forum software are in the ad

And will melt most lesser quality wood stoves into a molten pile on your living room floor:eek:

I saw brains and eggs out in W. Va. Scrapple in PA. Head cheese.... All no thank you for me:)

I get the seal kits online from one of the usual vendors, I've got it down to being a 1 beer job. Just pay attention to the order the seals go and it's straightforward. Need a pick set, something to pull the piston end off, I use a pipe wrench, some rags and a worm drive clamp to put the inner...

Rebuilt the FEL pistons on the L35. They were the last 2 left that haven't been done on my TLB. Should be good for another 18 years!

If you can't get it loose with the spanner get after it with a large pipe wrench and some heat. Break it loose while its mounted to the tractor to hold the cylinder still.

Yea that seems like a great price thanks for the link I sent them a email Also good to know. I notice the corners of the bucket are wearing on the outside edges so I need to get going on this.

Hi folks my front bucket has holes for a cutting edge, I'd like to get one. Do you guys build them or buy one? I'd like the bolts on the bottom recessed for back blading, etc. any ideas on this?

Here's a stump I pulled. I managed to get my bucket to lift it but ended up pushing it after going down the slight hill in the picture the rear end lifted off the ground, good thing I had my hand on the control to slam the bucket down.

Does anyone know if the engines in our tractors are flat tappet design?

1020 hrs on my 98 original clutch.