Search results

Let me know, I'm working on the loader for my B7100HST first and then I'm going to give this poor "parts" tractor a little attention. I'm usually all over South Texas for my "real job". It's amazing how badly your B6100 has been treated - I cannot fathom how a person can use so many incorrect...

Thanks for the sanity check! Definitely not going to spend too much time on hard surfaces or in 4WD!

Oops! I copied the wrong link - the 12-16.5 is recommended for a 9.75" The 10-16.5 is only 90" RC which would cause the ratio to be out of bounds. I could also go with a 18x8.5-10 front and 27x8.5-15 rear for a 1.507 ratio (-2.8%) and not need new wheels.

One last question - anyone know of any issues with mounting a 9.75" width tire on an 8.25" wheel? It doesn't look like anyone, anywhere, offers a 6x6 16.5" wheel. Anything 9.75" wide is an 8 lug setup.

Oof! That tractor started pretty rough! I'm of the same mindset, and I hate seeing mostly complete equipment neglected and fixed with hack repairs. The lack of stains and discoloration on the subframe/trans tunnel seems to confirm your assessment that the belly brace wasn't even bolted in...

Good morning, My B7100 HST-D has some very dry rotted turfs that need to go. I am keen on the newer R14t offerings from Titan/Goodyear, since I will be getting my B1630 loader put back together soon and installed on the tractor. Doing some research, there are no directly compatible sizes that...

My B1630 loader was in the same state as this one is - crushed and rusty lines. I'm using this as an opportunity to learn a new skill and to bend and flare some new stainless lines with new fittings. I'm basically rebuilding the loader hydraulics from scratch and reusing the arms, uprights...

IIRC - The D950 is the peak in that particular family (D650/750/850/950) and the D1100 is a different block to bellhousing bolt pattern. I believe the last two digits in the engine designator denote a "family" but I could be wrong.

FYI - received my block from @torch and it comes better packaged than parts from the Kubota mothership! I just need a few more bits to get my B1630 loader back in working order!

My B7100 has a very, very tired D850?950? from a later B7200/8200. Someone did it, and it kind of works. They cut the very straight hood to accommodate the intake pipe. I have a D750 intake manifold that I'm going to install to fix that.

What is the port size on the D850/950? I don't think it's NPT...BSPP?

Ah bummer, I hope he gets well. I'll shoot you a PM, I'm patient! I'm sure the fine folks at the US CBP will find a block of metal with holes highly interesting!

Do you still have these available?

I have to say, I have a pretty rusty B7100 that needs one of everything, but you're an absolute mad man. Well done, sir.

Oh no, I hope it's not the ebay guy that everyone recommends. I ordered a clutch kit from him!

My B7100 needs all the glow plug to start, even in warm weather. Like...a minute, easily. Very cold blooded.

My 3pt control lever is totally missing, just a hole where it should go. Definitely hacked by the prior owner I'd actually need the entire rockshaft lift housing from the trans case up with all the accessories to make this tractor properly whole again. Seat brackets can come with too, yours...

Howdy, I have a B7100D that I'm trying to put together missing the lift arm...everything. I think the prior owner used it as a hay ride rig. I need the control lever/valve, lift arms/shaft, plus the little rod deal on the side. Honestly, your whole back half is in better shape than the...