Search results

My guess is the 4 in 1 will not pick up near the amount of brush that a grapple will!

Thanks Henro I think im going to wait.

I remember reading about the shop vac trick! The trans fluid didnt look bad at all! Now the front axle fluid looked slightly darker.

That was my first thought but that screen is bothering me. Still kickin myself!

85Hokie I was thinking the same thing! Thanks!

I had the same question a while back. I dont use my rear PTO at all. The answer I got was theres no need to engage the pto to keep it lubed.

Well I screwed up doing my 400 hour service on my BX23S.! Ill chalk it up to old age and a new pup with me only 9 days! Distracted! I serviced the HST and refilled before cleaning the dang HST screen! Sooooo....I imagine if I pull the screen now all the fluid will drain out? Maybe just a...

Personally I would leave it be. Does your tractor have a plug in the engine block you can remove? Thats how I drained mine. I couldnt even get near the plug on mine. Too much in the way!

I was at my dealer today getting everything for my 400 hr service! Not many machines on the lot like in spring! There was only one BX23S so I went over to look at it. Same painted over zerks with grease on them, but nothing coming out of the joints! I wonder if Kubota has addresed this issue?

Paul that zerk on the right looks painted over! Although there is grease on the zerk I would make sure its coming out of the pin on the other side!

I would love to go with 3" spacers on my BX23S, but if my 54" mmm limits me to 1.25 then I dont think Ill even bother.

Clean the paint off those grease fittings and grease the hell out of it! I do wonder why those are painted over?

its the plug going to the starter! Push it together! Theres lots of play in the conector.

Well I just checked mine! Looks good! WAIT! I put a tape on the bracket and its about a 3/16th to 1/8th of an inch difference bottom to top! Other side (front) a tad more! If the bracket wasnt bent to begin with then THIS IS DEFINATELY WARPAGE from the welding process the 1/4" plate couldn't...

Very nice implement! I do wonder though how the loader arms hold up to all the abuse those buckets cause? Tractor loader arms can be bent easily as they arent really meant for digging like a bull doser. Not so much the OP but ive seen videos of these stump buckets ramming and lifting tractors...

You need to remove the 3 point hitch and.....Read the manual!

I love my BX23S! I bought mine because with all the projects I have to do it was cheeper to buy the tractor than to hire somebody to do the job! Maybe most buy them, finish their projects and then sell them? I found out I could have rented one for $500 a week rain or shine.....no thanks! Its at...

Pre BX23S models called for trans fluid change at 50 hours. The manual for the BX23S only calls for a filter change at 50 hours. I changed my fluid anyway since theres only a couple gallons in there. Cheap insurance! I notice your screen name.....must be a lever gun guy?

Did you check the air filter and intake? Could be starving for air.

Not using ballast also stresses the front axle and you could cause costly damage!