Search results

What you have is a Third function valve kit. I have an M6040 and the parts look very similar. The things that look like small relays, are the relays that open the electro-hydraulic valves. One is for open, the other for close. The two valve blocks with the grey brackets attached are the...

I live West of Orlando, I have a L245 and love it! I would be intrested in the parts. I would think it would be worth a rebuild.

The fuel lines from the tank to the injector pump my need to be bled first. Then bleed each injector line at the injector. If your Engine has a hand pump (I'm not sure about what you got) it is usually located on top of the filter. Then pump it till you build pressure in the lines. It some times...

This is called staking the nut. It's a common way to keep tork and vibration from working the nut loose. I usually just use a big socket and my large inpact gun......the twisting motion will push the nut back round. You can also use the chisels described above. Be sure not to leave a burr...

If that the case then I'm screwed. JWB

Dusty, good to hear from ya. JWB

Some of the kubota start switches go bad. They actually get loose on the back part of the switch. This causes the selinoid to no draw in hard enough to make contact. My l245 does this. I have to usually make it click three times before it will start. Try a remote starter button see if that works...

Eserv, Thank you for responding! I will add more oil to the hubs. I added approx 3.2 (I think that is what the WSM stated the capicty was.) U.S. quarts to each hub. It was not to the bottom of the threads as you describe. I have the kubota WSM that describes the procedure. I am quite shocked...

Can ANYONE help me out? Vic? Kubota tech? Eserve? JWB

Hello all, Here's one for the kubota guru's. I have an M6040 with 70 hrs on it. Did the inital service on it around 60 hrs. I have the WSM for the tractor and it shows to remove the 3 plugs in the wheel hubs, replace the bottom one when empty, fill till the fluid comes out of the middle one...

Go gators! Jwb

Your tractor doesn't have the rams to lift the three point like the newer M series tractors have. It should have two short arms that pivot just below the back of the seat. Under there is where you will need to be working. There is a piston, cylinder, and valving that will need attention. Get or...

Handy, Good tip! I do the same thing with valve guides. JWB

Here is some info that may help smooth out the um........language barrier. A freeze plug, frost plug, freeze out plug is usually shaped like a small ashtray.....it has a lip around the dish. Usually the dish is concave; that is that the dish faces in toward the block. The lip of the "ashtray"...

Try swapping out the batt. From another tractor or vehicle. It sounds like a cell in the batt. May be Shorted. JWB

Well of course you do. Your a part time amway salesman:). Just kidding. JWB

ANYTHING is possible for YOU, captain candle wax. JWB

Told ya so! ;) . Good job thanks for the update. JWB

Bump to the top. JWB

Sorry I can't help you but ill give you a bump back to the top. JWB