PTO wood chipper

[racerboy]

I don’t believe I have that load-level feature. At least I don’t see a lever that looks like the one you posted.

 

[McMXi]

I don’t believe I have that load-level feature. At least I don’t see a lever that looks like the one you posted.

OK ... was just curious if it's a common option for the L60 tractors.

 

[racerboy]

was able to remove my BH92 backhoe today for the first time. I also installed my 3-point hitch (also first time) and added my Speedco QH.

I’m still not sure how to set the telescoping arms and the top link. the first two photos show how the upper part of the arms are installed. There is about a 1/4” of play. Should these sit flush. The third photo shows the QH installed. Does this look correct? The last photo shows how much I had to extend the top link to make the QH is level. Is this OK?

 

[Kennyd4110]

Arms should be in and locked, then adjust the top link so the hitch is plumb. Looks good from here!

 

[McMXi]

was able to remove my BH92 backhoe today for the first time. I also installed my 3-point hitch (also first time) and added my Speedco QH.

I’m still not sure how to set the telescoping arms and the top link. the first two photos show how the upper part of the arms are installed. There is about a 1/4” of play. Should these sit flush. The third photo shows the QH installed. Does this look correct? The last photo shows how much I had to extend the top link to make the QH is level. Is this OK?

View attachment 172512 View attachment 172513 View attachment 172514 View attachment 172515

You could add a washer or two if you're not happy with the side to side free play where the side links (lift rods) connect to the rockshafts. My MX came with washers in place for that purpose.