Daily Chuckle

[Daren Todd]

 

[Fordtech86]

View attachment 90589

there is a video some where on the interwebs of a guy doing a strut job without a spring compressor just lays the strut on its side and zips the nut off with an impact

 

[Daren Todd]

there is a video some where on the interwebs of a guy doing a strut job without a spring compressor just lays the strut on its side and zips the nut off with an impact

Bet he won't do that again.

 

[dlsmith]

Bet he won't do that again.

At least not with the same arm.

 

[Fordtech86]

Bet he won't do that again.

I bet he does wish I could find it, I seen it a few years ago lol. It was more of a parody repair video, can’t remember how he put it back together

I’ve always had the proper tools available to do it right, but I could also do it safely without them . My bays at work were right next to the wall mounted spring compressor until they broke it, now we got a portable one. It provided free entertainment for me at work

 

[Daren Todd]

I bet he does wish I could find it, I seen it a few years ago lol. It was more of a parody repair video, can’t remember how he put it back together

I’ve always had the proper tools available to do it right, but I could also do it safely without them . My bays at work were right next to the wall mounted spring compressor until they broke it, now we got a portable one. It provided free entertainment for me at work

I had a bearing press fail while I was trying to press some bearings off from a shaft. The upper support rods w/ spring guides bent. I bailed as soon as I saw them start to bend.

150lb shaft tried to go through the wall

Ears were ringing for about 20 minutes. Had everyone who was in the office, out in the shop to see what happened.

Managed to clear all the dust out of the rafters as well. Few ceiling tiles came down in the office also.

Got me a new 30ton air over hydraulic bearing press out of the deal as well

 

[Fordtech86]

I had a bearing press fail while I was trying to press some bearings off from a shaft. The upper support rods w/ spring guides bent. I bailed as soon as I saw them start to bend.

150lb shaft tried to go through the wall

Ears were ringing for about 20 minutes. Had everyone who was in the office, out in the shop to see what happened.

Managed to clear all the dust out of the rafters as well. Few ceiling tiles came down in the office also.

Got me a new 30ton air over hydraulic bearing press out of the deal as well

ive had emergency surgery during a work day to have pieces of an air chisel bit removed from my chest . Ask my wife about the post anesthesia scene to get them pieces back so the snap on man could warranty it hospital never gave em to me, luckily the end of it was still in the air hammer when I got back to work insurance company came around a couple weeks later and asked for the bit, well half of its at the hospital and the other half on the snap on truck

 

[DustyRusty]

Now I know why Snap-On will not sell me the one broken part on my spring compressor, but wants the old one back and will ship me a new one. I should take care of that this week.

 

[Magicman]

 

[Bmyers]

 

[Daylight]

 

[Magicman]

I'll bet that "lamb" tasted like pork.

 

[Magicman]

 

[skeets]

Mary HAD a little lamb
Her Father killed it dead
Now Mary takes her lamb to school
Between two chunks of bread

 

[Daylight]

 

[Magicman]

 

[Toyboy]

 

[Magicman]

 

[Fordtech86]

 

[RCW]