What are you guys using for a Bearing supported stub shaft? I was just quoted over $1200 for a 1.5” shaft from Hayes.
Bearing support shaft
- Thread starter Floridaman
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
i wasn’t sure if the pillow lock bearings would be able to handle the speed (2800 rpm) or side load I would need to put on it. I’ve always seen them in low speed applications. I was looking at over hung load adapters, which appear to be beefier than the pillow blocks.
yea, that price caught me off guard also???? WHAT ?????
Original Bearing Supports | Hayes Manufacturing, Inc.
Have a pulley or an overhung clutch you need to drive? Look no further. Our Bearing Supported Stub Shafts allow you to side-load the back of an engine.
www.hayescouplings.com
$32
4000 RPM
4000 LBF STATIC LOAD
6600 LBF DYNAMIC LOAD
1-1/2" bore UCP208-24 Pillow Block Unit Bearing NP-1 1/2 VPS-224
Shop UCP208-24 pillow block bearing unit (1-1/2 in bore) at Bearings Direct. Cast iron housing with set screw for easy installation.
bearingsdirect.com
$68
1045 TGP SHAFT
ANSI 3/8" KEYWAY
You can probsnly get both from Surplus Center
Dan
Last edited:
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
No... WHAT? As in What are you trying to do?
Lots of different scenarios for a bearing and a shaft.
1 1/2 shaft size is HUGE!
You building a D9 CAT?
Lots of different scenarios for a bearing and a shaft.
1 1/2 shaft size is HUGE!
You building a D9 CAT?
sorry, just saw this. I’m building a pressure washer For my business.
im on the verge of pulling the trigger on a Isuzu 80hp. i was going with 1.5” shaft due to the torque and horsepower of the engine 80hp/140tq. Didn’t want to run into any problems.
Below is a picture of what I might be purchasing tomorrow.
