Search results

Looking for a valve cover for my L275 in good shape.

Thanks, guys! Not very familiar with these engines and the service manual leaves a lot to be desired. Just wanted to make sure I was not missing something.

I had to replace the gear housing/case on my l275 and cannot find any procedure for adjusting the bolt identified in this diagram as #1 in the Kubota service manual for the engine. Can anyone tell me how it's supposed to be adjusted?

Delete.... Old gasket was so hard and compressed it just looked like the bottom of the valve cover was flat.

Thank you!

I'm rebuilding the engine for my L275 and am trying to hang the pistons on the rods. The pistons have a red dot on the underside which I would assume needs to be oriented toward the front of the engine, but I cannot find any mention of it in the factory service manual. I cannot see any...

Bumping this up and adding this question: Is there anyone that sells remanufactured engines for these ready to go?

I'm about to tear down the engine in my L275. I don't yet know the extent of the damage, but it it sounds like it may have spun a bearing or damaged a piston. Cranking over it, you can hear compression-compression-clunk......compression-compression-clunk. Anyway I'm looking at parts and a...

I have not recently done any work with the injector lines, but I'll check just in case. As a further bit of information, the tachometer quit working a few weeks before this started.

I have a service manual and owners manual, but neither one has much information on the engine in my L275. It recently started blowing dark smoke and feeling like its running on two cylinders. The manuals I have don't give me much guidance on diagnosing this problem. Where can I find one that...

It appears to be hydraulic oil. I messed with it a bit yesterday and the lever for the front end loader was stuck between positions. I released the lever and the oil seemed to slow substantially. I let it run with a drain pan below and it never quit completely, but I think it was just letting...

Hello All, I found this forum in hopes of getting help figuring out what has happened to my tractor. A few weeks ago, I used it to cut some brush and all was fine. I parked in my normal spot and shut down as always. A couple of weeks later, I went to do some more cutting and a few moments...