Search results

Great. Stop cutting and start pulling then. I thought you were trying to hold this infirm piece of trunk to the remainder of the more solid tree with the cable you mentioned.

Well that’s interesting. Those two hex screws appear to hold the valve to the bracket or vice versa. I wouldn’t think they would interact with the hydraulic fluid in the valve body. Also, there’s no need for a bleeder in the 3rd function’s system, leastwise not in my Land Pride system. Will be...

Get a line high in that limb and pull in a rope? Then pull it down with the tractor a ways out of the fall zone?

The 4060 is way more tractor. Good call. The width and length will be within a couple inches of the 3901. Apparently the ROPS isn’t as it was thought? Normally an 8’ tall garage door won’t have an 96 inch opening height that it covers. The door overlaps the opening on the top. Maybe you can...

Yup.

Same here. Dewalt blower. Turn the engine off first. I blow mind baby B off after mowing.

Report it stolen to law enforcement. They won’t care, but when you see it for sale, at least there will be a pre-existing report to back up your claim.

That’s a literal pile of garbage. They must be offering $20k to have it removed? Love how the bottom chord of the trusses has been cut off to facilitate the palatial ambiance. Next winter the roof will collapse under 6 inches of snow when the walls blowout. It still snows in Maine, right? Hope...

Same issue here. I probably have a half dozen 2 cycle Stihl power heads and two or three Stihl units with the 4 mix engines. I do not like the low rev on the 4 mix engines. It is not good on the weed eaters in heavy grass. My HT131 pole saw does pretty good with the 4 mix engine. My 85 yo FIL...

I don’t think the width and performance of a multi fixed blade MMM can be directly related to a rear PTO driven rotary cutter with a single pivot (two hinged blades on a stump jumper). The MMM certainly won’t cut in the first cut of the season conditions I mentioned above (unless maybe the deck...

Depends on what you’re cuttting. My L3830 has 30 PTO Hp and it won’t cut wire grass over about 0.5 mph. On the first cutting each year of 2 to 2.5 ft tall pasture grass it is limited to about 1 to 2 mph. This is with a 60 inch brush hog (rotary cutter), set so that the skid shoes are 1 inch...

Nice. How is it mounted to the three point?

You’ll enjoy this new tractor. I have the same one with a 54 inch MMM. It is a nice mowing tractor for me. Congratulations.

That’s exactly what I was thinking. Probably needed to turn the engine off and dust off the grill before that stage.

A few Grade 2 bolts are probably less expensive than the next weak link in the system.

Regarding the cam lock handle, yours is a bit bent, mine is a perfect 90 bend. But I do agree, you have to back away from the loader just a bit to fully disengage the cam lock and remove the gang plug.

I have a couple images that I have easy access to at the moment as to how the quick connect hydraulic gang connection for the FEL mounts on my B2601. I can’t attach them as they are too large, 4.5 MB. I don’t recall it being restricted or hitting anything relative to preventing the connection...

In life it’s often about the journey rather than the intermediate goals. Sounds like a good time. I had an old NA diesel in a Chevy (6.2L, IIRC. I think the military used them in light duty rigs as well). The fuel filter would restrict flow when it got water accumulated in it. The. The old beast...

I was probably 15 before I realized you could buy new parts. Growing up with little money and a lot of make do know how was actually a good thing.

I believe the new oil filters are painted while on the machine? That would make them seem pretty tight.