Search results

Is there not a brownish rubber hose coming from the rocker cover area hanging down below the bottom of the crankcase? Its like an old fashioned road draft tube on 60's back car's and trucks. Oops, showing my age. kytim

What? No way! I knew I was doing something wrong. HAHA, that's funny. I didnt see it coming. kytim

<<<<A added bonus is when the wife's in the house barking orders the tractor is outside and very relaxing. You will find yourself creating projects just to spend quality time with your orange baby. A Kubota is more than a tractor, it part of the family.>>>> Well, I don't have a wife currently...

I'd like to read that... kytim

Well there are not that many possibilities to consider. 1 an loose or broken cable is the most likely problem. look to see first if the outer sheath is connected at both ends. if not bingo, you found it but, if still attached you need to loosen it from both ends to check the actual flexible...

Sorry Bro! looks like you got hit with the big "C", the clutch. just about all of us has been there at one time or another. kytim

Well Johnny you are in luck. the great folks that provide this wonderful resource, orange tractor talks, also will sell you a manual for almost any kubota tractor, etc. Look at the very first sticky post in the buy/sell section. prices are as good or better as other places that offer them. What...

that sensor is actually the low pressure switch. Is that where you jumped it at? or at the compressor clutch itself? to troubleshoot some more remove the plug from the switch only jump there with all controls on high. if it runs you either have a low gas situation or a faulty switch. report...

Good job on the cab... that will make a HUGH difference during the chilly times of the year. the Plow mount looks like one of their factory units. I wish I still had the Meyer plow the I used to have on a 78 1 ton chevy 4x4 dually. It was a good plow and I liked it over other brands i've seen...

WoW! Nice Job... looks like a well thought out addition. I would be proud to have such a setup. kytim

Hi and welcome. If your speaking about a hyd top link ...then yes you would need a spool valve of some design to control it. I will tell you that many a hole has been drilled/dug in varying soils without the use of such a device. Someone with more experience and insight will surely offer you...

At least it didn't cost you anything to fix it!! Now go get yourself some seat time and enjoy! kytim

Great, wonderful, and 2 or 3 other big words I to tired to spell! Glad you got it running! kytim

Nice. Hope you got a deal! kytim

I personally believe introducing <<any>> water into the fuel system is not a good idea at all. We work hard to remove very small amounts of water in fuel, especially when in colder climates. i would use some form of distillate. Kytim

is there a difference in one from a HST and a gear drive trans tractor?? tim

So did you make a deal? got pics? kytim

+1 on the shaft

Joe, Welcome to the forum!! And secondly, time spent on the forum from a new person to the site owner has nothing to do with being able to offer good sound advice, suggestions and even encouragement to others. all are welcome and encouraged to communicate ideas with one another. I know when I...

Begin your troubleshooting by cleaning up the areas that are suspect. A little oil will spread into a large area, especially with heat involved. the heat tends to thin oils that allow it to migrate to other areas. when clean run/work the machine and check frequently for leakage/seepage. areas...