Search results

I run a 64 inch LandPride On my B2650 and it works really well. I also use the same set up on my BX 2670 with no issues as long as I ran it with the loader on for ballast. I live in the snow belt of the western UP of Michigan

Yes , it’s the snap ring. This is a new deck with around 5-10 hours on it. Both sides have let go once. The other side hasn’t since I installed a new clip. I’m guessing the dealer installed the wrong clips at set up?? Idk?? I pulled them off yesterday to see if I could use tie wire, there’s not...

Its the part above the wheel. There’s no room or no way to pin or bolt it to the shaft. There’s just a glove for the C-clip.

Here’s the wheel set up.

Unfortunately they can only be installed one way. Its happed to each side now. It’s the clip that holds the orange frame (yoke) onto the Shaft that pins to the mower deck. It’s possible the wrong clips were used but they fit tight. It seems the must catch on a root just right and rather than...

The wheel is bolted on. The part that comes off is the where the shaft and frame mount with the above C-clip. It acts as a caster.

This is the second time my front deck (RCK60-30BA) wheels have came off. Today the C-clip came off (which I found) and the wheel went under the deck while mowing. I installed a new C-clip and machine bushing to limp the wheel a long until I pick up a new one. Kinda scary seeing that thing go...

I had to do this this weekend. No way could I relive the pressure with anything I tried to push inside the loader side couplers. Once I cracked the lines they went on easy.

There’s 2 knobs, one as you stated for deck height. Back that one off and back off the other one that adjusts the speed the deck drops.

Talked with my brother who’s friends with the owner of this tractor. He said he blew a hydraulic line. I didn’t ask what one. I guess that’s good news considering what it looked like.

I’ve seen on the Kioti FB page of this happing but not so much on the Kubotas.

I’ve been using Wix on everything I own for over 27 years. I never had a issue with them. IMO Wix is top of the line in filters.

Seen a B2650 Pissin oil/hydro fluid from under the hood. Stopped by and talked to the owner and he thought it was only oil. It was milky so im guessing the hydro pump is pushing Hydro oil into the engine? Bummer!

From what Neil has said, there’s confusion between the 2 B series. Do to one being smaller than the other. Sounds like it’s just rebadging them to clear up the confusion.

Blower is 500 on Land prides spec site. Tractor is 2293( I had this wrong from the earlier post) on Kubotas site according to there spec sheet. If the deck is 450 I need to lay off energy drinks cause I move it around by hand no problem. Lol Im assuming the loader is around 400-450Lbs. I...

Around 2300lbs with the blower. Im looking for a car hauler or equipment trailer again. My B2650 dont fit in my enclosed car hauler.

From what he states in the video, the are only changing up the larger B series to the L series. The compact B series remains unchanged. The reason for this change is just that, to much confusion with two B series.

A dealer installed LEDs on the side of my ROPS. I removed the lights and traded my BX2670 with holes in the ROPS to a different dealer on my new tractor. They weren’t worried one bit about the modification.

Vert true!! After a few mins of moving snow I have it set down to the lowest setting with the temp on the cooler side.

We Received 10” Monday and Tuesday. I do like the fresh snow as I like to snowmobile in the sticks. I haven’t seen that forecast yet.. I do like the cab. The heater will roast you out.