Search results

I’m fully expecting to find some worn parts in this thing .

I have a block heater on mine and it works awesome especially if your unit is outdoors . Make sure you make the plug in end long enough , disconnecting and reconnecting it will be a pain otherwise

Having issues with my ALO hydraulic valve . I’ve posted a picture for reference , the 3-4 side has no issues but if you look where I’ve labelled 1-2 it is shorter and seems to be stuck. I originally thought the cable was pooched. The pressure from the pump is fine. Just wondering if I should be...

I got the new pump installed. Checked all my coolant lines and pressure tested it and held over a minute. Everything is running good again . As always appreciate this forum for the help you all provide .

Every brand of tractor has their awesome and not so awesome models. Kubota for the most part is a fairly reliable tractor. Their engines a pretty bullet proof.

it leaks from the 2 bottom bolts that hold the pump to the block . Might be easier and more expensive just to replace it. Machine has 1860 hrs

sorry for a piss poor quality picture . I put the pressure tester on it and the leak is coming from between the water pump and the engine block . I inserted a new seal between the 2, lined it up and torqued it to spec. Why would it still leak?? Thx

Anyone have an idea what this could be ? I’ve pulled the water pump and it seems to be ok. I’m not sure where this is Comin from . Machine is an m100. I was underneath the tractor when I took this

So I’ve checked the water line hoses for the oil cooler and all the water pump hoses . I’ve also pulled the water pump and changed the seal on the back side. I’m still getting coolant dripping in these areas . See picture . I don’t see any leaks from the head. Help

I use the Milwaukee , but that’s what a lot of my tools are .

Not sure what I’m doing wrong

My m100 is leaking between the water pump and engine block. I’ve replaced the seal between the 2. Any tips or tricks to get this thing to seal properly ? Thanks

Best to spend the 30$ and get a copy from your local Kubota dealer.

B7152 Baldwin should work for l4701dt As for oil, I just typically stick with whatever the manual recommends. You can deviate depending what climates your facing ,just do your research. Best of luck.

Hello, I just got a water gasket and some o ring replacements for my water pump on my m100x. Is there a trick To getting the hard coolant line with o ring to set in the pump ? Having little difficulty. Any tips appreciated. Thank you

Baldwin.

Rtv 1120 stopped going in either direction . Pulled the engine transmission out . I don’t see any damage to the coupler. Looked at the gears in the transmission nothing seems to be overly worn or damaged . I haven’t taken apart the hst yet . Would a worn swash plate cause no movement ? Really...

My hydraulic oil tank is at the appropriate level on the dipstick . I’ve also checked the oil for the transmission and it’s spot on. Suction/transmission filters are brand new. My linkages are all adjusted to factory spec. I disconnected the shifter and manually tried to get the transmission to...

BSPP pipe fittings. Make sure you invest into a decent hydraulic test kit. You’ll need one.

I’ve read on a few forums people having issues with these so I’m not sure if I should just yank the entire unit out for inspection or if there’s other ways to test other components. It will not drive forward or reverse or engage. My service intervals are impeccable.