Search results

Buddy just had this problem, treated all of His fuel, but still had to buy a bunch of filters. I guess periodic checks need to be done.

Two pins under axle,and two pins on lift Arms. I have to pull blocks off and back away. Tried it tonight. A little bit of a pain. Going To turn blocks 90 degrees so they narrower and Easier to back over. Pushes that 50" wide blade full Of gravel.putting my pictures on photobucket, Easier to...

Hello everyone. I spent a day toying around with the idea of a front blade Operated with three point hitch. This is on my l1501 tractor 11 foot i beam, 4-1/2 foot pusher blade Pivot under axle and welded a bar to connect to 3 point Lift arms. Two feet behind that are two 24x30 patio blocks...

I have a 1000 watt inverter.i have used it On long trips to power all kinds of things, It draws less than 50 amps at any given Time. Average alternator puts out 100+ amps. A low wattage oil pan heater is what i would Consider.

Buddy pulls a 250 gallon water tank, has a Hypro roller pump on pto. Uses it for controlled Burning.not at all suitable for fire fighting. For controlled burning a tractor mounted Tank in my opinion is too small

No go, aftermarket ag dealers in my Neck of the woods dont even list Such a piece.i was in the parts biz For quite a few years, i know the Local ag suppliers and not one has A link with one eye and one clevis. Thinking i can turn something out On the lathe, buy oem or adapt something To go...

Have discovered my three point adjustable Lift rod has had the biscuit. Thanks to another member, and the parts list He provided i need a 99511-22512 . Thanks again ,Daren. So, what im asking, anything out there a Good substitute? Someone welded a nut on one end and used allthread To patch...

In my past experience, the parts guys can figure Out what a person is after with a good description Of the part. In many cases, the repair manual doesent Match the parts manual in regards to Naming the part. A bushing for instance May be called a bearing. Seems to me there are different...

I Am so impressed with this little powerhouse, Beyond anything i expected. Made up a Trailer reciever for a ball hitch and Pocket for two -2" square tubes to use for Pallets. Moved a ton of stuff on pallets and 8 boats out of winter storage. Compared to my 6 cyl gas job , this putt putt...

Hopefully i can find a few cheap accessories and a service manual of some sort Blade tiller and snowblower would be my goal It will certainly run my pellet mill,i imagine it will sip Fuel compared to my cockshutt with a six cylinder gas. Mill only needs 8-10 hp to work.

Hello everyone, just picked up L1501 tractor (792 hours) Couldnt resist. Looking forward to learning all about this fine little machine Have a L4610 hst at work that i maintain. Is a good machine. Will be definetly tapping into the resources here, as an automotive Tech by trade i i may have...