Search results

Having the same issue hooking up. The top hook on the quick connect is so large it won't hook underneath the top pin without me getting off the tractor, removing the pin, back in further, then put pin in. Does this on both ballast box and my back blade. Bad idea to grind down some of the hook...

Did find a barely used 6 foot back blade. A little wider than I wanted but the pins are 32 inches apart so will work great with the quick connect. Will get it and see how it goes. Will sell the other one if this works out.

Appreciate your help. Am looking at a full rod going across but would have to drill the holes in the center to get it all the way through. If I go extension, just worried those pins will bend. Will have to see what I have around the garage to see if I have any small pipe to use to try 1st...

Am considering extending off the nipple but wasn't sure it will be strong enough. Need 3 inches on each side. Not sure I can get the nipples off as a bit of rust around the bolt. Thanks.

yes

Picked up a 3 point quick attachment. My older landpride back blade isn’t wide enough at the lower pins. Need 30 inches end to end To fit on the quick attach. Am at 24 inches. Bushings are not long enough. Should I run a 30 inch bar through the holes of the pins I would need to remove? Any other...

High RPM’s and a ballast box on the back maxed out on weight. Should lift with no problem. Let me guess, your back tires came off the ground trying to lift a full buck.

Already ordered. 2 sets for $33.19 from amazon. Thant looks good too though.

Got a response from Titan. Said to send a video of me putting the bushing on before they decide what to do. Told them I will this weekend but did send them a picture of my finger through it and mentioned what I was told on this forum. No response yet. My other order comes in Wednesday and will...

Didn’t think they made those pads anymore. Put one on my 1 ton in late 90’s on the pan. Worked great. Entire engine stays warm. I’ll be ordering one for my 1880. Thanks.

That looks good. Don’t think it would work on mine. Mine is a stubby plastic piece.

Do this with your ROPS. I let it rest on the pins and goes in garage great.

Get the $90 one. Has both straight and wide beam.

Just looked at the manual. Doesn’t state anything about that slot. But, a warning about releasing it before turning so guess that’s not what I thought it was. Thanks for questioning it. Now I know.

That looks great. Thanks for the idea.

Look at the picture. Has a slot to slide it in to keep it engaged. Never used it yet. May lock it in when snow plow duties start.

Maybe just leave it locked in until I need to unlock it. $110 buys allot of diesel fuel.

Thanks. The top one looks like it will work but $110 is a bit steep.

My 1880 has this small pedal to engage the rear axel lock. Sometimes it’s a bitch to get my heel to press it down. Does anyone make a larger one?

How much? I paid $33.19 for 2 sets from amazon.