Search results

thank you for the quick reply. I was going through the whole thing before cold weather really gets here. It is a standard transmission . Thanks again

I have a 1980 B6100D with 2000 hrs on it. I have always used 80w 90 fluid in it. Question is would it be ok to change it to SUDT. The winters can get pretty cold in NH.

Thank you Wolfman. I can now put the pump back and continue working on the rest of it while I wait for the cylinders.

Wolfman Could I have run the engine without removing the pump as long as I don't touch the levers? I was afraid it oil would have come out the open lines.

Removed the lift cylinders and it will be a while before I get the new ones, Meanwile I am fixing oil leaks on the engine. I'm wondering if I can still run the engine if I put the valve in float position so it would recirculate the fluid to the reservoir without spewing out the open ends, The...

Wolfman I used the blue Loctite thread locker #242. I cleaned it up good with acetone both the male and female. I put Loctite on both male and female and tightened it right down. I then waited one of the longest 24 hours I've ever had.You can't believe the urge to just try it before the time...

Wolfman I ordered the right fitting but I'm not sure that's what it was. When I put it in the piece went easy at first than half way hard. I still had quite a few threads left to go so I put more pressure. Dumb. What I was thinking of trying was using blue treadlock to see if it works. I was...

Bought my adapter to convert to the gauge and found out the broken brass piece that I drilled out was not done right.when I put the new one in it leaked like a sieve .When I tried it the first time was with the loader on and I must not have been straight. There are still some thread left. I...

Thank you wolfman just ordered it. I got the one that you can hook it up both ways.

Trying to convert oil light to gauge. Tried a brass adapter and broke it off in the block. 2 days to take it out with a dremel tool and tiny carbide bits. wondering if anyone tried this with steel adapter and were to buy it. seems these days the older I get the dumber. I should have known right...

Thank you all for your response I have the workshop manual and will pay more attention to it from know on.

what are the torque values for my bolts on my B6100 kubota tractor.

Thank you I guess I put in enough to last me a life time.

how much grease am I supposed to put in. there does not seem to be any coming out anywhere. have done all the greasing and oil changes and this is the only one I don't understand.

Thank You for the chart. I'll use it for sure