Search results

Found the picture, but no part number. I would call the local dealer or Messicks.

https://www.messicks.com/KU/194179?sectionId=376091&diagramId=3732419

They provide an owners manual and expect the customer to read it and understand it. In the future if oil light is on to turn the engine off immediately. Do you have KTAC insurance on it? Do you have any insurance on it? I know I replaced an engine for an insurance company that the owner tried to...

Go Backwards...

Does it run on methane?

Take out of 4wd or jack the front end up too.

How are you checking wires? An ohm meter, test light, or led test light? 8K wow. How much is a new harness?

I would look at the mounts for the bumper as they might be bent, from your pictures I can see the bumper does not fit right, but does not look bent. In older vehicles they had a shock like thing to absorb the impact , back did not always come but out. Some pictures of how in mounts might be...

Its your tractor way of telling you it's time for hydraulic top and tilt. :ROFLMAO: :eek: :ROFLMAO:

You have never worked at flat rate if you think it includes coffee breaks. Heck in the automotive world every quarter the labor flat time changes, and it usually goes down.

Or for free you could just remove the starter relay.

I have seen idiots use salt water instead of windshield washer fluid. It RUSTED the pump out, as in the pump was blotted and had rust streaks down the pump and tank. Also seen DEF put into the washer system, at least that made cool looking spider webs on the hood, roof, windshield, and fenders.

The groove in the middle is for grease to be distributed when/if you grease your loader. At the end of the pin find a bolt that fits and locate the same hole on the bucket, install a bolt with a little blue loc-tite on the nut.

Great time to replace the fluid, just get a couple of 5 gal buckets of kubota fluid.

I run a 63 inch snowblower with my LX2610 which I believes has 19 hp at the PTO. It does struggle with 8 inches of heavy wet snow, just have to go a little slower, does fine with 9 inches of dry snow. The cab on the tractor does make it really nice in the winter(think snow blowing in your t-shirt).

If you can remove the shaft and start the engine is the noise gone?

Do you have pressure on the C clamps? Have you reviewed the owners manuals on the procedure?

I have been running dexos 2(GM) motor oil 5w30 as I try to only have a half dozen of different grades of oil. Just make sure the oil is rated for diesel engines. Diesel engine oil has different properties than gasoline oil. The 15W-40 "diesel" oil wins in a lot of things: It will have stouter...

bump

That flex coupling is missing a bolt it looks like. Need a picture of the ujoint.