Wildfire
Active member
Equipment
Kubota L5740 HSTC3 and a Kubota ZG222Z, 2013 BX25D,Custom Toyota fork lift.
I'm calling this mod #1 although I already got a few others done but I'll post on them later.
This is a ripper tooth I fabricated. It's pretty well built from scrap around the shop. It weighs 36 lbs so that's not to bad considering the bucket weighs around 40 lbs. As you can see I also added a replaceable tooth. I figured it was better to do that rather than wear out the bottom of the tooth. I had planned to add the ripper tooth to the bucket but changed my mind because if I did it that way I would get the benefit from my thumb plus the change over from bucket to tooth is less than 5 minutes.
I guess the pictures will tell the story. In one photo you'll see a small shaft I machined. I threaded each end to hold the pin keepers in place that way I wouldn't have to use a nut on the inside to fasten the bolt plus the solid 3/4 shaft will add some strength to the mount. I made the tooth out of 1 plate and cut it with the Miller plasma. I welded it with the Millermatic 350 P in pulse mode and I included some photo's of how the welds look. I should have taken a few more photo's but when I'm doing something like this I sometimes get so involved in it I loose track of time and forget about the camera
Anyway you'll get the idea. I figured I'll use this on some tough ground and aiding in pulling tree roots. A big thank you to my lovely wife for designing and cutting the graphics.
I add photo's of more mods as time will allow.
This is a ripper tooth I fabricated. It's pretty well built from scrap around the shop. It weighs 36 lbs so that's not to bad considering the bucket weighs around 40 lbs. As you can see I also added a replaceable tooth. I figured it was better to do that rather than wear out the bottom of the tooth. I had planned to add the ripper tooth to the bucket but changed my mind because if I did it that way I would get the benefit from my thumb plus the change over from bucket to tooth is less than 5 minutes.
I guess the pictures will tell the story. In one photo you'll see a small shaft I machined. I threaded each end to hold the pin keepers in place that way I wouldn't have to use a nut on the inside to fasten the bolt plus the solid 3/4 shaft will add some strength to the mount. I made the tooth out of 1 plate and cut it with the Miller plasma. I welded it with the Millermatic 350 P in pulse mode and I included some photo's of how the welds look. I should have taken a few more photo's but when I'm doing something like this I sometimes get so involved in it I loose track of time and forget about the camera
Anyway you'll get the idea. I figured I'll use this on some tough ground and aiding in pulling tree roots. A big thank you to my lovely wife for designing and cutting the graphics.
I add photo's of more mods as time will allow.
.
