New profile posts

Need a Non-Kubota opinion. We have a 2011 Merc. Mariner with the 2.5L engine and 80,000 miles. It starts, runs fine but the challenge is sometimes it is somewhat difficult to put into reverse. My wife thinks it has to do with the brakes because if she pumps the brakes a couple of times it has started. Or she turns the engine off, with her foot on the brake and it shifts. It is only doing this probable once every 20-25 times when going to reverse.

I looked up TSB #47976 which says the converter pilot hub needs Morocraft multippurpose gease spray XL-5-A. Are you familiar with any problems like I describe? I'm thinking about taking the car to a good transmission shop (I know the owner) and have him go over any linkage that may be dry or binding.

Any words of wisdom? Thanks. Len

New to Kubota and this forum

Hey guys, I'm fixing to buy a TG1860 diesel that hasn't run for a few years. is there a valve that I can open up to allow the wheels to freewheel so that I can push it up onto my trailer that has a ramp?

Equipment
JD 647 tiller, Kubota 301 loader , JD LX4 rough cut mower, 48” Box blade, 6ft 3 pt hitch diamond harrows

New to me BX24 inbound

Hi Thanks everyone - i did insure my tractor now --thanks for the info

Hi -- I need recommendation on tractor insurance ---I don't have a farm and I I take my tractor on the road
Where can i buy tractor insurance

New to the forum as of TODAY!

Using the new robotics feature!!!

U55-4 Excavator
L2900 tractor with BL4690 backhoe and LA480 loader
BX 1860 with RCK48P mower
B7200 manual drive
B7200 HST

Teaching Automation in College, retired from INCO (the nickel guys).
Happy digging with the Orange machine!

One more post was missing from a thread about a B670 BH parts list, but that thread has not been re-posted by the OP, so no place to re-post my answer.

Posts that were just gone & I replaced were in "B7100 3pt hitch and ball hitch connection" from Service, Repair, & maintenance".

Also " So Now That Winter is Approaching" from "Off Topic"

The pics I mentioned needing to be replaced, "Show Us Your Shop & Equipment" posts 134-138, from "Off Topic"

Mr K,
Now I am having trouble trying to answer your inquiry- I keep getting a message "oops we ran into a problem, please post a message with less than 420 characters"

I serviced my L3940 and forgot to cut the fuel back on after changing the fuel filter. I started the tractor and it ran of course until it ran out of fuel, I cut the fuel back on it would turnover and attempt to start, but no cigar. I opened the cock on the fuel pump per the owners manual and cracked the fuel lines at the injectors to bleed off air, but still had no luck.
Any insights?
Thanks
Ed

My kubota stalled immediately after getting up off the seat. Any ideas why?

Looking for a B4200 front end loader complete

Also, the kit came with a pilot bearing, but, I don't see where it goes.

So I drained the hyd fluid, cleaned filter, pulled the tractor apart installed new disc, clutch, and release bearing and it still will not go into gear while running. The clutch linkage is adjusted all the way out.