What did you do to or on your Kubota today?

dirtydeed

Well-known member
Lifetime Member

Equipment
B2650 BH77, U27-4R2, BX23TLBM, box blade, rear blade, flail mower, Stump Grinder
Dec 8, 2017
3,549
5,425
113
Wind Gap, PA
I bought a used one 3 years ago. I use it almost more than my tractor. Cut firewood? Lift the logs to waist height (with a thumb) and buck it up. No more bending over. Lift the heavy rounds onto the splitter or on a table to feed the splitter. Need to lift something heavy out of truck bed? Sling or chain the load and lift it out. Tractor stuck in mud?Pull it out with mini-ex. Obviously excels at digging and trenching and is easier than using a backhoe. Dozer blade takes more punishment than tractor bucket for pushing/grading. You'll suddenly find all your neighbors will become your "best friends" as they find "favors" they need done. Would not want to be without my L6060, but I consider my KX033 an essential piece of equipment on the farm. Enjoy!
How do you like that Mongo?
 

Gaspasser

Well-known member
Lifetime Member

Equipment
L6060, FEL, forks, front snowblower. KX033 mini ex. Dump truck, Husqvarna saws.
Dec 16, 2023
307
433
63
NH
How do you like that Mongo?
It works and is well made. I bought one of their ripper blades a few years back and liked the customer service. Must be careful with excessive/extreme curl as hoses get exposed to ground.
 
  • Like
Reactions: 1 user

g_man

Well-known member

Equipment
L3010DT, M5640SUD, Dresser TD7G
Feb 3, 2023
246
1,116
93
NE Vermont
I had a Red Maple succumb to the wind earlier this year. I pulled it out for firewood yesterday with the L3010 and Farmi 290 . At about 12 feet up the tree forked into two leaders. Both leaders split off, each going in opposite directions. One laying flat on the ground and the other remained partially attached to the snag and up off the ground.


25_8_21-1.JPG



I had a good winching lane up to the snag. The leaders were 90* to the lane. I hung a snatch block on a birch (little orange blob) and winched out the side that was on the ground first. The other leader is in the foreground up off the ground.


25_8_21-2.JPG



Then I hung the block on the snag and pulled out the other leader.


25_8_21-3.JPG



I cut the snag and winched it down to the tractor also. I cut one leader 24' long the other 21' plus some limb wood from each side.


25_8_21-4.JPG


gg
 
  • Like
Reactions: 5 users