She is brand new BX2370 and has a runny nose (hydrolic fluid from loader). Placed paper towel to find the leak.
What did you do to or on your Kubota today?
- Thread starter gurn
- Start date
I finally got my tractor(L4600 4x4 with FEL) today!! My dealer brought it in on a trailer and picked up my 200, sorry to see it go, been around a long time. Of course it was cold and starting to rain when he brought it and I was right in the middle of hanging Christmas lights on my 2 story house. I had a whole 2 minutes of seat time while I was putting it in the barn to get it out of the rain. I bought pallet forks for it also, maybe I'll get to play with it soon!
BAP
Well-known member
Lifetime Member
Equipment
2012 Kubota 2920, 60MMM, FEL, BH65 48" Bush Hog, 60"Backblade, B2782B Snowblower
Put my tire chains on this afternoon. I had been holding off till it looked more like snow. They are talking 3-5 inches here tonight, so I figured it would be easier to put them on while it was dry and mid 30's out than to wait until snow was on ground and much colder. Now if we only get enough to push around.
I fixed a front turf tire flat. They're predicting some snow over the weekend so I decided to check the tractor. The right front was down to 10 psi, others were good. I couldn't see anything obvious except some chicken litter in the treads, but it's only been about 2 weeks since I checked tire pressure and was surprised it was that low. Went in the house and got a 1 gal jug of warm soapy water to clean off the frozen litter and look for the leak. All of the litter washed off except for one spot. There were a bunch of tiny little bubbles coming out from under it. That piece of litter turns out to be the mashed woody end of a 2 1/2" Hawthorn tree thorn. I pulled it with a pair of needle nose pliers, got my tubless tire repair kit, plugged it up, aired it up, good as new. I hate Hawthorn trees!
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Took the B for a spin up and back on the mile moving a little wet snow with the back blade.
Trying to get the loader mounted front blade done so it can be sent to my mom for snow removal duty for them.
I'm going to be sad to see her go out on lease.
Trying to get the loader mounted front blade done so it can be sent to my mom for snow removal duty for them.
I'm going to be sad to see her go out on lease.
Gundoctor
New member
Lifetime Member
Equipment
Kubota M7040 4x4/ BX2230 4x4/ JD MX 8/ Ford 101 Moldboard 3 bottom Plows -
Snow plow is on the M7040 and just waiting for it. They are calling for 8-10 inches tonight. This morning it was -13' COLD!!
David Pidgeon
New Haven, Vermont
David Pidgeon
New Haven, Vermont
Attachments
Well, cancelled out on our Christmas shopping excursion because of snowstorm... then, my neighbor called and his septic was plugged so I got to go over and dig up distrib box. Prob solved!
Had to figure out why the headlights on the Bx 1500 quit working. Turned out the dash mounted rocker switch internal contact had become pitted and wouldn't make contact. Took apart the switch and scratched up the contact surface and walah we have lights!
Lil Foot
Well-known member
Lifetime Member
Equipment
1979 B7100DT Gear, Nissan Hanix N150-2 Excavator
Did this a few months ago, just now getting around to posting.
Had to dig up a stop and waste water valve to replace it, valve was down at 39" deep, tight quarters between cabin, porch, and water hydrant.
Had to dig up a stop and waste water valve to replace it, valve was down at 39" deep, tight quarters between cabin, porch, and water hydrant.
Attachments
FINALLY....I got to move some snow today with my tractor. , we've had 12" + another 4" so I've plowed with my truck twice. So today I went out and bucketed and pushed some snow around... I'm more pleased with my tractor then ever.
BAP
Well-known member
Lifetime Member
Equipment
2012 Kubota 2920, 60MMM, FEL, BH65 48" Bush Hog, 60"Backblade, B2782B Snowblower
Plowed my driveway again. Got 4.5 inches last night. Have moved snow 5 times in the last 9 days. Gives me some Kubota time. Glad I added more lights to the tractor this fall.
RCW
Well-known member
Lifetime Member
Equipment
BX2360, FEL, MMM, BX2750D snowblower. 1953 Minneapolis Moline ZAU
I did this, for the umpteenth time. That's my backyard, so my dog has a place to go potty.
Lights are workin' good.
BX2750D has yet to blow a shear bolt. That's why I have spares, then you won't need 'em.
Skeets - The first couple times I used them, thought the location of the worklights were going to be a problem on the BX2360 because of glare. Hasn't been an issue last few times.
Attachments
Wildfire
Active member
Equipment
Kubota L5740 HSTC3 and a Kubota ZG222Z, 2013 BX25D,Custom Toyota fork lift.
Oh that looks sooooooo coldI did this, for the umpteenth time. That's my backyard, so my dog has a place to go potty.
Lights are workin' good.
BX2750D has yet to blow a shear bolt. That's why I have spares, then you won't need 'em.
Skeets - The first couple times I used them, thought the location of the worklights were going to be a problem on the BX2360 because of glare. Hasn't been an issue last few times.
I've been snow blowing. We had nothing until last Sunday when we got 8 inches, then 12 on Wednesday, then about four this morning. They're calling for more on Sunday.