Good afternoon, I have a 2014ish ZG124E zero turn that I had to replace the motor on. I put a new 25 hp Briggs and I can not get it to start with the key. I can jump the solenoid with a screw driver and it will run and drive but the blades will not turn on. 1 thing I noticed is the old motor had an oil sensor and the new one doesn’t so the plug from the mower has an open pin from the plug from the motor. There is a red jumper wire going to an open pin on the mower side but not sure if I can just move that one with out shorting something out. 2 other things I had trouble checking was the seat switch and brake switch. The seat switch wasn’t checking out right and the brake switch is a pain to get to but I was hoping you could let me know if the plug was an issue before chasing down the other 2 issues. Any help would be greatly appreciated.