QH16

[kcs]

I have one of these on my B2650 one side hooks fine. The other seems too wide is this the right QH for my tractor?

 

[kcs]

Here are some pictures

 

[GreensvilleJay]

Just downloaded the spec sheet, hook to hook center is 28 1/4", CAT1 implements should be 26" I think...

 

[cthomas]

What is it? SDoes the implement have a QH compatibility sticker?

 

[Trimley]

Here are some pictures

Can you flip the brackets on the implement? It looks like you could gain (or narrow) width by doing so. I think you could add washers (both sides) between bracket and implement to get the width you need.

 

[GreensvilleJay]

I looked at the pix again, the 'arms' are offset welded, but bolted onto the 'implement' , so maybe you can flip them over to gain some distance ??
OK, it's orange, but WHAT is it ???

 

[rc51stierhoff]

It’s hard to say from the pics, but I wonder if your link arms are same length and is the implement square to the QH with arms centered and same length? Is there any sway to the link arms?…could it be canted/off center?

 

[Trimley]

I looked at the pix again, the 'arms' are offset welded, but bolted onto the 'implement' , so maybe you can flip them over to gain some distance ??
OK, it's orange, but WHAT is it ???

You more/less said the same thing I did above you!

 

[GreensvilleJay]

somehow.. your post #5 'magically' showed up AFTER I'd posted #6, but not instantly...sigh
admittedly I'm a dinosaur, I expect 5 to come BEFORE 6.....
must be this 'new math ' being applied to computerz...

 

[kcs]

Wow thanks for all the answers. I will try flipping the arms tomorrow. It is a finish mower. 60”. Not sure if the model. The upper hook hooks to the flexible link right. Looks like the stable link is too big for the hook on the QH Sorry I’m new with the tractor stuff and QH

 

[Elliott in GA]

As mentioned twice above, you probably need to flip the arms and maybe move them to the inside of the mounting plate.

I had to adjust/remount mine on my LP Finish mower to fit my QH10.

 

[Elliott in GA]

Wow thanks for all the answers. I will try flipping the arms tomorrow. It is a finish mower. 60”. Not sure if the model. The upper hook hooks to the flexible link right. Looks like the stable link is too big for the hook on the QH Sorry I’m new with the tractor stuff and QH

If it is like mine, the QH hook does not hook to anything. The plates that came with my QH attach to the Y yolk at the top of the mower A frame. This mounting system allows for maximum mower float.

 

[kcs]

Awesome. Thanks. I got the finish mower when I got the tractor and got the QH a few weeks ago. Old man and bad back needed some help. I will try reversing them tomorrow. OTT is the greatest.

 

[Mak65]

Not sure which finish mower you have but the FDR16 has this in its feature document…
Lower hitch points adjust in and out
Accommodates many tractor configurations by adjusting in and out. So, as everyone said switch them.