Play in HST pedal worn bushing on trans

[Speedybon]

I have B-7800 that has play in the forward/reverse pedal. What I found was a worn bushing mounted lever mounted way inside on the transmission I think this looks like a problem. What it does is make the forward/reverse pedal have travel in the neutral position. The year is a 1993 HST B-7800. I have parts manuel and a owners manuel so I am trying to find what I need. Any help would be apprieated

 

[GreensvilleJay]

Curious was I....Probably 2 pcs of #020, bushing $5 each ?? Maybe #070, while your at it ?? Check for slop at #100-120

 

[Speedybon]

I have B-7800 that has play in the forward/reverse pedal. What I found was a worn bushing mounted lever mounted way inside on the transmission I think this looks like a problem. What it does is make the forward/reverse pedal have travel in the neutral position. The year is a 1993 HST B-7800. I have parts manuel and a owners manuel so I am trying to find what I need. Any help would be apprieated

 

[Speedybon]

What I found that I think I need in the Page 107 Neutral Holder link #20 bearing?

i did find the ball bearing and there is a updated design
ASSY.ARM,NEUTRAL
Part # 6C150-43413

 

[Speedybon]

Well I found the concern it is the Neutral holder. Its is the roller that failed, it looks no fun. I hope the roller is the new up grade.

 

[Speedybon]

B7800 neutral centering problem. Arm ass. #20 bearing. Not going to be a fun job, It looks like the case is supose to separate the case. I did find a link on tractor.net It should work? https://www.tractorbynet.com/forums...as-bs-creeping-neutral.html?highlight=neutral

 

[Butch]

I had to replace THAT bearing on my B2410 a few years back. The bearing was toast. even a couple of "balls" had fallen out. It is a quick and simple swap out ..... but getting to it is a BIt%^$ !!!

 

[Speedybon]

Will my 2003 Kubota B7800 should be repair tomorrow as soon as the bearing gets here from Messicks. It was not the most fun job. Getting the race off was the hardess part. Also looking for my gray Kubota paint was my next job. Here are some pictures.

 

[Butch]

Will my 2003 Kubota B7800 should be repair tomorrow as soon as the bearing gets here from Messicks. It was not the most fun job. Getting the race off was the hardess part. Also looking for my gray Kubota paint was my next job. Here are some pictures.

I should have mentioned the easy way to get the race off... I used a Dremel Tool and a cone grinder to slowly cut it.... took maybe 20 minutes. When it got razor thin ... it just popped apart and I slipped it off with two fingers.

 

[GreensvilleJay]

Think I'd rather work on the JEEP, and why is the hood up ? Saying 'me next ???? '

 

[Speedybon]

Think I'd rather work on the JEEP, and why is the hood up ? Saying 'me next ???? '

I restored the this jeep so I like looking at it. Did you know it was concered a muscle car in its day,

 

[Henro]

I had to replace THAT bearing on my B2410 a few years back. The bearing was toast. even a couple of "balls" had fallen out. It is a quick and simple swap out ..... but getting to it is a BIt%^$ !!!

Here I thought you would have said “Getting to it was a Butch!"