M7060 ENG NG code

[Cklawns82]

Hey All,

I parked my M7060 at my hunting property a few months ago.

From Winter use the shuttle shift has seized. I'm attempting to remove the push pull cable, or at least unhook so I can manually put it in neutral to get the machine started.

Within the time it's sat a mouse got inside the cab and setup shop under the seat behind the metal cover.

At this point I can't get the machine to turn over. Shuttle shift needs to be in neutral correct?

There is a code on the display (Eng Ng).

I found the wire going to the fuel sending unit? On top of the tank had to have been chewed through since I parked it.

I stripped the 2 wires and have them temporarily connected back together.

The code still reads on the dash.

I checked the ECU & ecu backup fuses and they are good.

I'm stumped currently and need to get the tractor to my shop.

Please help. Thanks, Chris

 

[mcfarmall]

I would venture to say that you have more mouse damage than you know of at this time.

 

[Dustyx2]

I would venture to say that you have more mouse damage than you know of at this time.

I agree. NG per the service manual: "Engine trouble, etc. CAN Communication ERROR between Engine ECU and Tractor ECU"

 

[Cklawns82]

I agree. NG per the service manual: "Engine trouble, etc. CAN Communication ERROR between Engine ECU and Tractor ECU"

I really need to know, with the code that's displaying, will the machine e at least start? Once I get the shuttle shift into neutral that is.

 

[Dustyx2]

I would think not. Engine ECU is right above and to the rear of the air filter housing. The Tractor ECU is under the right side interior panel approximately below the PTO switch, so a fair amount of wire loom to look at. Removing that panel and the floor panel should allow you look at the wiring loom.

 

[Hkb82]

Did you find the issue. Update would be nice to hear.

 

[Dustyx2]

Did you find the issue. Update would be nice to hear.

Looks like he has moved on. Not seen since Nov. 6th.