Hello, I have a M7040 that was submerged under water for approx 30 minutes. I have changed all the fluids and replaced the rear brake discs. I have a clunkimg noise in the right rear axle/wheel area. It's started the clunking when on the brakes right before the tractor comes to a complete stop.
M7040 clucking in rear end when coming to a stop
- Thread starter Mikec575
- Start date
No sir it was clunking before I changed the disc. I think as thinking the discs is what was causing the clunking that's why I changed them.
This might sound a little strange to you but you can try raising the cab mounts and putting a piece of rubber in-between the frame and cab tighten it back down and see if that helps. If it does you can replace the mounts
It could also be internal like swash plate or if that model uses electronic shif solenoids not sure would have to check wsm.
It could also be internal like swash plate or if that model uses electronic shif solenoids not sure would have to check wsm.
Yes. I had an occasional rear end clunk that came from loose disk to rim bolts that took me awhile to find.