New to forum, just bought a L4150, serial # 10029. I am looking for a hydraulic remote add on, either a kit or control valve. Kubota does not offer one anymore. Either new or used is fine, thanks, Flattop
L4150 remote
- Thread starter flattop
- Start date
Any competent hydraulic shop can do this, or the dealer.
If you already have an FEL, you can usually get some kind of power beyond setup going that does what you need as well. You can try Ebay for an aftermarket kit or call Surplus Center and they can usually help build one up for you to install.
If you already have an FEL, you can usually get some kind of power beyond setup going that does what you need as well. You can try Ebay for an aftermarket kit or call Surplus Center and they can usually help build one up for you to install.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Any open center valve will do the job.
The factory setup wasn't all that great for that tractor.
The factory setup wasn't all that great for that tractor.
Attachments
To flattop,
Not sure if you are still on this forum, but I am wondering if you ever managed to get some remotes installed on your L4150. I just picked up an L4150 and am facing the same challenge. Did you find an aftermarket valve that would fit? Would appreciate any insight you may have on this topic. Thanks!
Jay
Not sure if you are still on this forum, but I am wondering if you ever managed to get some remotes installed on your L4150. I just picked up an L4150 and am facing the same challenge. Did you find an aftermarket valve that would fit? Would appreciate any insight you may have on this topic. Thanks!
Jay
Jay, did you get the power beyond and 3 rd function going on your 4150. Same boat here, like to do the front and add a hydraulic top link.
TheOldHokie
Well-known member
Lifetime Member
Equipment
L3901/LA525, B7200DT/B1630, G2160/RCK60, G2460/RCK60
That exchange was two years ago. Adding remotes to that tractor is trivial. What does "want to do the front" mean?
Dan
TheOldHokie
Well-known member
Lifetime Member
Equipment
L3901/LA525, B7200DT/B1630, G2160/RCK60, G2460/RCK60
A third function valve is typically mounted on or near the loader valve. There are "universal" kits for kits for installing a pushbutton operated electric valve. They provide the basic pieces but you have to do a little fabrication to mount them on your particualr machine:
Universal Hydraulic Third Function Valve Kit w/ Joystick Handle, 15 GPM
Free Shipping Universal Hydraulic Third Function Valve Kit w/ Joystick Handle, 15 GPM
summit-hydraulics.com
Another option is to use a much less expensive manual valve. I would consider it a better solution for controlling something like an auger. You can also add moire than one spool and use the additional spool(s) for rear remotes. It could be mounted on the loader or the fender like the OEM valves. If its on the fender it would remain with the tractor should you remove the loader.
Dan